User manual OLIMPIA SPLENDID SECCO BROCHURE

[. . . ] 55 Sliding the appliance into the installation niche . 59 Attaching the appliance to the installation niche . 62 Attaching and aligning the custom door front . 73 3 IMPORTANT SAFETY INSTRUCTIONS When using the appliance, follow basic safety precautions, including the following: Read all instructions before installation and use to prevent accidents and machine damage. Electrical Safety ~ Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. [. . . ] The room temperature is lower than the ambient temperature for which the appliance is designed. 34 Frequently asked questions General problems Issue Possible fault Solution Water is flowing out of Close the shut-off valve immediately. Check whether the water Contact Miele Technical pipe in the appliance is Service. Check whether the water pressure is too low. Contact a plumber. Check whether the correct Self-tapping valves and water valve has been 3/16" (4. 76 mm) saddle installed. valves reduce the water pressure and can block the pipe. freezer section will not The suction caused by open. opening and closing the door too many times in succession prevents it from opening. The compressor kicks The ventilation slits are on very frequently and covered or dusty. The door has been opened too frequently, or a large amount of unfrozen food has been put in at once for freezing. It should now open without force. Clean with a vacuum or brush. Once the freezer gets down to the set temperature the compressor will turn off. See "Water filter" for more information. Check the water pressure. The water pressure must be between 25 and 120 psi (1. 72-8. 25 bar). Check whether the correct water valve has been installed. The ice cubes have When ice is stored for an an unpleasant extended period it may odor/flavor. Check if the ice cube container is dirty. Unsealed packages in the freezer will transfer odor/flavor particles to the ice cubes. Self-tapping valves and 3/16" (4. 76 mm) saddle valves reduce the water pressure and can block the pipe. Use the ice maker more frequently. Clean the container. Check that food has been packed in airtight containers. 38 Frequently asked questions Problems with the ice maker Issue The ice maker is not producing enough ice or the ice cubes are misshapen. Possible fault Check the water pressure. The water pressure must be between 25 and 120 psi (1. 72-8. 25 bar). [. . . ] Extension cords do not guarantee the required safety of the appliance (danger of overheating). If any changes are needed to the household wiring or power supply, this work must be performed by a qualified electrician. 72 RemoteVision Miele's RemoteVision Wi-Fi technology creates a 'virtual link' between your appliance and our monitoring center. If a fault occurs, Miele's client service center will be notified and contact you, or another trusted individual identified on your call roster, in order to gain access to your appliance to fix the problem. For information on set-up and installation of the RemoteVision module see the "Installation" section of this manual. [. . . ]