User manual OLIMPIA SPLENDID SECCOPUR S BROCHURE

[. . . ] 30 General problems with the dishwasher . 44 Cleaning the drain pump and non-return valve . 51 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Electrical Safety Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent injury and machine damage. [. . . ] If the door is closed, the program will continue from where it was interrupted. , Open the door with care. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. Changing a program If the detergent flap is already open do not change the program. If a program has already started and you wish to change it: ^ Press the "Start/Stop" button for at least one second. The "Start/Stop" indicator lights. ^ Select and start the desired program. 27 Additional functions Factory default All settings can be reset to the factory default. ^ Press the "Start/Stop" button and at the same time turn the dishwasher on s. Hold the "Start/Stop" button until the "Start/Stop" indicator comes on. The bottom program indicator flashes once long and twice short in intervals. The "Rinse" indicator shows if a setting was changed. See "User Maintenance Instructions" for more information on the above. ­ Remove any kinks in the drain hose. 30 Frequently asked questions General problems with the dishwasher Issue Detergent is left in the dispenser at the end of a program. The detergent lid cannot be closed properly. The door and the interior walls are still wet after a program has finished. Water remains in the wash cabinet at the end of a program. Possible fault The dispenser was damp when detergent was added. Detergent residue is blocking the catch. Solution Dry the dispenser before adding detergent. Remove the residue. This is not a fault!The moisture will evaporate It is the normal operating after a short time. Before fixing the fault: ­ Turn the dishwasher off s. [. . . ] The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. , Improper connection of the equipment grounding conductor can result in electric shock. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 49 Plumbing Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. [. . . ]