User manual OLIVETTI COPIA 9912

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "0" on the copier instead of "ON" and "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. If anything is not included or is damaged, contact your dealer. [. . . ] To copy from the preheat mode, make desired copier selections and press the print ( ) key using the normal copying procedure. Auto power shut-off mode When the copier enters the auto power shut-off mode, the power save (i) indicator will light up and other indicators will go out. The auto power shut-off mode saves more power than the preheat mode but requires a longer time before starting copying. To copy from the auto power shut-off mode, press the print ( ) key. Then make desired copier selections and press the print ( ) key using the normal copying procedure. Auto clear (page 1-20) The copier returns to the initial settings a preset amount of time after the last copy is made. This preset amount of time (auto clear time) can be changed. To enter the toner save mode, press the light ({) key. The exposure indicator marked "1" will light up, indicating the toner save mode is selected. To return to the standard mode, repeat the procedure but use the dark (}) key to select exposure level "5" in step 3. Press and hold down the exposure mode selector key for approximately 5 seconds. The user programs allow the parameters of certain functions to be set, changed, or cancelled as desired. Setting the power save modes and auto clear time, and stream feeding mode. Press and hold down the light ({) and dark ( }) keys simultaneously for more than 5 seconds until all the alarm indicators (w, t, s) blink and "­ ­ " appears in the display. Use the left copy quantity (<) key to select a user program number. The selected number will blink in the left side of the display. The entered program number will be steadily lit and the currently selected parameter number for the program will blink on the right side of the display. 5 Auto power 0¶OFF shut-off mode * 1¶ON Factory default settings are indicated with an asterisk (*). Select the desired parameter using the right copy quantity (<) key. To change the setting or to set another mode, press the clear (>) key. Press the light ({) or dark (}) key to return to the normal copy mode. Be sure to use only genuine parts and supplies. [. . . ] If the covers are closed in the wrong order, the covers may be damaged. Raise the handle of the paper tray and pull the paper tray out until it stops. Push the center of the pressure plate down until it locks in place and secure the plate using the pressure plate lock which has been stored in the front of the paper tray. Use a coin (or suitable object) to attach to the left side of the copier the screw that has been stored in the front of the paper tray. [. . . ]