User manual OLIVETTI COPIA 9915F

[. . . ] These can be re-used for transporting the machine, should it be necessary. WARNING: Provided with some models only ACHTUNG: Wird nur mit einigen Modellen geliefert BEMÆRK: Leveres kun sammen med enkelte modeller 1 2 3 4 5 6 7 Original cover Side cover Manual bypass Paper guides Side cover open button Front cover Paper tray (two paper trays may be available depending on the model) 8 Operation panel 9 Original table 10 Cover for optional printer interface 11 12 13 14 15 16 17 18 19 20 Paper output tray Paper output tray extension Handle Power switch Power cord socket TD cartridge lock release button TD cartridge Drum cartridge Drum cartridge handle Transfer charger 21 22 23 24 25 26 27 28 29 30 Charger cleaner Fusing unit release tab Paper feed roller SPF and R-SPF exit area Middle tray Original guides Document feeder tray Feeding roller cover Bypass tray Bypass tray guides 1-12) 2 Light ({) and dark (}) keys and exposure indicators Use to adjust the MANUAL (=) or PHOTO ( ) exposure level. Q Paper feed location indicator Light up to show the selected paper feed station. Two paper trays may be available depending on the model. [. . . ] Make sure that the first and second originals are oriented in the same way on the original table. Both the first and second originals can be set in the SPF but they must be set separately. If the stream feeding mode for the SPF has been enabled, set the second original after the SPF ( ) indicator goes out. For tablet binding, turn the first copy over left to right as shown below. For booklet binding, turn the first copy over top to bottom (not shown). Feed the first copy into the manual bypass or into the bypass tray. Be sure to feed the copy paper one sheet at a time. Power save modes (page 1-20) The copier has two power save modes of operation: preheat mode and auto power shut-off mode. Preheat mode When the copier enters the preheat mode, the power save (i) indicator will light up and other indicators will remain on or off as before. In this condition, the fuser in the copier is maintained at a lower heat level, thereby saving power. To copy from the preheat mode, make desired copier selections and press the print ( ) key using the normal copying procedure. for more information on purchasing the TD cartridge , see SUPPLY PART NUMBERS AND STORAGE on page 1-37. If copying is continued while the indicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure given below. After the copier stops, it may be possible to make a few more copies by taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge. During a long copy run of a dark original, the ready ( ) indicator may blink, the s indicator light up, and the copier stop, even though toner is left. The copier automatically replenish the toner level for up to 2 minutes and then the ready ( ) indicator will light up. Ensure that the bypass tray is open and then open the side cover while pressing the side cover open button. Then, push gently on both sides of the front cover to open the cover. Gently pull the TD cartridge out whilst 2. Pose of the old TD cartridge in accordDie alte Entwicklereinheit gemäß den örtance with local regulations. [. . . ] 2 Push gently on both sides of the front cover to open the cover. Gently pull the TD cartridge out while pressing the lock release button. Close the front cover and then the side cover. When closing the covers, be sure to close the front cover securely and then close the side cover. [. . . ]