User manual OLIVETTI D-COPIA 120/150

[. . . ] PUBLICATION ISSUED BY: Olivetti Tecnost S. p. A. Divisione Business Prodotti Office Via Jervis, 77 -10015 Ivrea (TO) www. olivettitecnost. com Copyright © 2003, Olivetti Tutti i diritti riservati All rights reserved CAUTIONS Cautions on using Follow the cautions below when using this unit. Warning: · The fusing area is hot. Exercise care in this area when removing misfed paper. · Do not look directly at the light source. [. . . ] If the original cover is not securely closed, the copies may be striped or blurred. · The original cover can be simply lifted straight up and reattached to allow copying of a large original (12 cpm model only) 5 1 2 Open the original cover/SPF, and place the original. Place an original face down on the original table. Align it with the original scale and the centering ( ) mark. Gently close the original cover/SPF. Original scale mark 47 Using the SPF The SPF is designed to hold up to 30 originals measuring from A5 to A4/Legal and weighting from 52 to 90 g/m2. · Before feeding originals in the original feeder tray, be sure to remove any staples or paper clips from them. · Before placing curled or wavy originals into the original feeder tray, be sure to flatten them. · The SPF ( ) indicator on the operation panel will light up. If this indicator does not light up, the originals are not properly set or the SPF is not properly closed. · Badly damaged originals may misfeed in the SPF. It is recommended that such originals be copied from the original table. · Special originals such as transparency film should not be fed through the SPF, but should be placed directly on the original table. 4 mm) can occur at the leading and trailing edges of the copies. 4. 5 mm in total) can occur along the other edges of the copies. · To stop continuous copying using the SPF, press the clear ( ) key. 1 2 Make sure that no original is left on the original table. Adjust the original guides to the size of originals. 3 Set the originals face up in the original feeder tray. Original face up Stream feeding mode The stream feeding mode allows easy operation of continuous copying from the SPF. If the stream feeding mode has been enabled using user program No. 4, the SPF ( ) indicator will blink approximately 5 seconds after the last original has been fed by the SPF. While this indicator is blinking, any new originals placed in the original feeder tray will be fed and copied automatically. If the stream feeding mode has been disabled, the start ( ) key must be pressed each time the originals are set even immediately after completion of a copy run from the SPF. The default setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p. 53). 48 SET THE COPY QUANTITY Set the number of copies using the two copy quantity ( from the original table or from the SPF if installed. , ) keys when copying · Press the clear ( ) key to clear an entry if a mistake is made. [. . . ] Upon termination you must destroy the Software and related documentation and all copies thereof. 4. Export Law Assurances. You agree and certify that neither the Software nor any other technical data received from OLIVETTI, nor the direct product thereof, will be exported outside the United States except as authorized and as permitted by the laws and regulations of the United States. If the Software has been rightfully obtained by you outside of the United States, you agree that you will not re-export the Software nor any other technical data received from OLIVETTI, nor the direct product thereof, except as permitted by the laws and regulations of the United States and the laws and the regulation of the jurisdiction in which you obtained the Software. 5. Government End Users. If you are acquiring the Software on behalf of any unit or agency of the United States Government, the following provisions apply. [. . . ]