User manual OLIVETTI D-COPIA 6200

[. . . ] · Do not look directly at the light source. · Do not switch the unit rapidly on and off. After turning the unit off, wait 10 to 15 seconds before turning it back on. · Unit power must be turned off before installing any supplies. Caution: · Place the unit on a firm, level surface. [. . . ] The remaining print data will be sent to the unit and printing will resume. Interrupt copying is not possible during a print job using the single bypass. ORIGINAL PLACEMENT Using the original table · The original table can read up to A4 original. · Image loss 4 mm can occur at the leading and trailing edges of the copies. Also image loss 4. 5 mm in total can occur along the other edges of the copies. It can be 6 mm (max. ) at the trailing edge of the second copy of two-sided copying. · When copying a book or an original which has been folded or a crumpled original, press down the original cover lightly. If the original cover is not securely closed, the copies may be striped or blurred. · The original cover can be simply lifted straight up and reattached to allow copying of a large original (12 cpm model only) 5 1 2 Open the original cover/SPF, and place the original. Place an original face down on the original table. Align it with the original scale and the centering ( ) mark. Gently close the original cover/SPF. Original scale mark 47 Setting a large original (12 cpm model only) The original cover can be removed to allow copying of bulky objects. 1 Simply lift the original cover straight up. 2 To reattach the original cover, reverse the above procedure. Using the SPF The SPF is designed to hold up to 30 originals measuring from A5 to A4 and weighting from 52 to 90 g/m2. To adjust the copy density manually or to copy photographs, the exposure level can be adjusted in two steps manually. The copy resolution used for AUTO and MANUAL ( changed. (p. 56) ) mode can be 1 Press the exposure mode selector key to select the MANUAL ( ) mode or PHOTO ( ) mode. 2 Use the light ( ) and dark ( ) keys to adjust the exposure level. If exposure level 2 is selected, the two left-handmost indicators for that level will light up simultaneously. Also, if level 4 is selected, the two righthandmost indicators for that level will light up simultaneously. 50 Automatic exposure adjustment This automatic exposure level will remain in effect until you change it again by this procedure. The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from the original table and copying from the SPF respectively. 1 When adjusting the automatic exposure level for copying from the SPF, place an original in the original feeder tray and make sure that the SPF ( ) indicator lights up. When adjusting the level for copying from the original table, make sure that no original is left in the original feeder tray. Press the exposure mode selector key to select the photo ( ) mode. 2 3 Press and hold down the exposure mode selector key for approximately 5 seconds. The photo ( ) indicator will go out and the AUTO indicator will begin to blink. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up. Press the light ( ) or dark ( ) key to lighten or darken the automatic exposure level as desired. If exposure level 2 is selected, the two left-handmost indicators for that level will light up simultaneously. [. . . ] You may not electronically transmit the Software from one computer to another or over a network. 3. Termination. This license is effective until terminated. You may terminate this License at any time by destroying the Software and related documentation and all copies thereof. This License will terminate immediately without notice from OLIVETTI and/or OLIVETTI'S Licensors if you fail to comply with any provision of this License. [. . . ]