User manual OLIVETTI D-COPIA 31 SETUP GUIDE

[. . . ] 533321R d-Copia 23 d-Copia 31 COPIER OPERATION MANUAL Please read the instruction handbook before using the copier. Keep it close to the copier for easy reference. PUBLICATION ISSUED BY: Olivetti Lexikon, S. p. A. Direzione Home/Office Via Jervis, 77 - 10015 Ivrea (ITALY) www. olivettilexikon. com Copyright © 2000, Olivetti All rights reserved October 2000 The manufacturer reserves the right to carry out modifications to the product described in this manual at any time and without any notice. ENERGY STAR is a U. S. registered mark. The ENERGY STAR program is an energy reduction plan introduced by theUnited States Environmental Protection Agency in response to environmental issues and for the purpose of advancing the development and utilization of more energy efficient office equipment. This machine has been approved, under the terms of Council Decision 98/482/EC, for Europe-wide connection as a single terminal to an analogue Public Switched Telephone System (PSTN) system. [. . . ] When finished scanning, replace the original and scan accordingly. 12. After all the originals have been scanned, press the Start key. Arrange the originals in a stack with the first to be copied on top. Set them in the DF and press the Start key. Copying will start. (13) Making image overlays [Form overlay] This mode can be used to read the first original into memory and have its image laid over onto copies made from subsequent originals. The exposure of overlaid image can be adjusted. 39 FUNCTIONS 1. Press the Image key to light the indicator. The function selection screen will appear. 2. Press the cursor down key to select "OVERLAY", and press the enter key. The form overlay setting screen will appear. 3. Press the cursor down or up key to select the copy exposure of the overlay original. The exposure level can be selected from 10 steps between 10% and 100%. Make sure that "ENTER" has been selected and press the enter key. 6. * If originals are set in the DF, set the image overlay original as the first sheet. * If originals are set on the platen, set the image overlay original first. 7. * If originals are set in the DF, all originals are scanned one by one and copying performed accordingly. * If an original is set on the platen, go to the next step. 40 FUNCTIONS 8. Replace the original after one original has been scanned, and press the Start key. * If more originals are to be copied, set other originals in the same manner. (14) Inverting black and white [Invert copy] Black and white areas of the image are inverted (reversed) when copied. * If multiple inverted copies are performed, "PLEASE WAIT. Press the Image key to light the indicator. The function selection screen will appear. 3. [. . . ] When copying onto transparencies or paper which cannot be set in the drawer, install the multi-bypass. When using the hand-out mode (page 27) or the sheet copy (page 29), install the multi-bypass. q Program mode Up to three combinations of copy modes and functions can be registered in the program mode (page 45 and page 46). q Copier management The total number of copies made by each department can be managed for up to 250 departments in the copy management mode (page 49). [. . . ]