User manual OLIVETTI JET-LAB 600@

[. . . ] 237204C-01 User's manual PUBLISHED BY: Olivetti TECHCENTER, Localit Le Vieux, 11020 ARNAD (Italy) Copyright 2000, Olivetti All rights reserved Editors: Olivetti Lexikon, S. p. A. , Divisone Home/Office, Via Jervis 11 - 10015 Ivrea (Italy) The manufacturer reserves the right to make any changes to the machine described in this manual, at any time, and without prior warning. This machine has been approved, under the terms of Council Decision 98/482/EC, for Europewide connection as a single terminal to an analogue Public Switched Telephone System (PSTN) system. However, due to differences between individual PSTNs in the various countries, the approval does unconditionally guarantee success operation of every PSTN termination point. If you encounter any problems, you should contact your supplier immediately. In accordance with directive 1999/05/CE, conformity to quality requirements is attested to, by the affixing of the mark on the machine. Network compatibility declaration This product has been designed and developed to operate in the networks of all European Community countries, and in those of Switzerland and Norway. Full compatibility with the networks of individual countries will depend on specific national software parameters which can be set in the product. [. . . ] This may include: - the name of the remote party that called you, or - PRIVATE: where the remote party has chosen not to reveal their identity, or - NOT AVAILABLE: where a remote party is connected to a telephone network that does not offer this service, or - NOT RECEIVED: where the remote party's name was not received. This may include: - the number of the remote party that called you, or - PRIVATE: where the remote party has chosen not to reveal their identity, or - FAX2NET: where the transaction has taken place using the Internet provider. - NOT AVAILABLE: where the remote party is connected to a telephone network that does not offer this service, or - NOT RECEIVED: where the caller's number was not received. Date/time: - Date and time at which the call was received. FACSIMILE 43 Enabling/disabling the automatic printing of successful and unsuccessful transmission reports . . . Ensure that the display shows the initial waiting mode and the date and time. RX ON FAX 11-10-99 100% 12:24 Enabling/disabling the automatic printing of broadcast transmission reports . . . Ensure that the display shows the initial waiting mode and the date and time. Press the FUNCTION key. 1. MEMORY TX /1-9 2. Press the FUNCTION key. 1. MEMORY TX /1-9 3. Press 8 on the numeric key pad. 8. SETUP /1-9 3. Press 8 on the numeric key pad. 8. SETUP /1-9 4. Press the START key. DATE AND TIME 4. Press the START key. DATE AND TIME 5. Press the FUNCTION key. VARIOUS SETTINGS VARIOUS SETTINGS 6. Press the START key until the display shows: 6. Press the START key until the display shows: TX. REPORT:NO BROADCAST REPORT:YES 7. Press the options available: " TX REPORT:ALWAYS" and "TX REPORT:FAILED". TX REPORT:FAILED 7. Press the available: "BROADCAST REPORT: NO". BROADCAST REPORT:NO 8. Press the START key to confirm this choice, then Choosing "REPORT TX:FAILED" sets the fax machine to print a report automatically, but only after failed transmissions. "REPORT TX: ALWAYS" sets the fax to print a report after each and every transmission, irrespective of the result. [. . . ] Check that your contact's machine is connected, switched on and free and that the number called is correct. Interference on the line or some other fault. Try re-transmitting, starting from the page number indicated on the transmission report. The pages indicated were not transmitted. [. . . ]