User manual OLIVETTI OLIBOARD

[. . . ] The manufacturer reserves the right to carry out modifications to the product described in this manual at any time and without any notice. Your attention is drawn to the following actions which could compromise the conformance guaranteed above, as well as the technical features of the product: · incorrect electrical power supply; · Incorrect installation, incorrect or improper use or use not in compliance with the warnings provided in the User's Manual supplied with the product; · Replacement of original components or accessories with others of a type not approved by the manufacturer, or performed by unauthorised personnel. No part of this material may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording or similar, without prior permission in writing from Olivetti S. The content of this manual can be modified without warning. [. . . ] If this warning persists, make sure that the driver of the USB cable is installed correctly (see the note on how to check installation of the USB cable on page 13). NOTE: After having started the driver, click on the icon of the Oliboard driver to activate or deactivate the "autostart" parameter, depending on whether or not you want the Oliboard driver to be run automatically the next time the computer is powered on. if the computer is permanently connected to the whiteboard , it is advisable to activate "autostart". On the other hand, if the computer could be disconnected from the whiteboard, it is advisable to deactivate "autostart" to avoid an error message appearing the next time the computer is powered on which indicates that no whiteboard is connected. This function serves to tune the whiteboard for the image to be projected onto it. Using the mouse left button, click on the Oliboard Driver icon in the control bar at the bottom. Select "Orientation" in the popup menu, then select the type of orientation required (see the INSTRUCTION note at the end of this paragraph). NOTE: The orientation operation can also be activated by means of the special key at the top of the Function Key panel on the whiteboard. Wth the mouse left button click on "Re-orientation" to open the popup window for Orientation. With the electronic pen, click on the mid-point of the flashing cross "+" on the whiteboard. Repeat this same operation for all the other orientation points (there are six in all), being careful to canter well the mid-point of the flashing cross with the electronic pen. INSTRUCTION: Select "Re-orientation" the first time you install the Oliboard Driver or if the position of the projector or the Interactive Whiteboard changes, or if the display mode changes (e. To perform a rapid re-orientation, you can select "Previous re-orientation record" as long as no changes have been made since it was last used. If an accurate orientation is not required, you can select "Default orientation". A Logon window opens in which you can enter the user name and the password. To start the software using the default account, click simply on the "Login" button without entering any data, otherwise you can enter your own personal account. When a personal account is used, the user can customise the tool bar, resources and templates. If the computer is often disconnected to the whiteboard, it is advisable to deactivate the automatic execution by means of the Startup Applications Preferences panel to avoid an error message appearing the next time the computer is powered on indicating that no whiteboard is connected. Click on the driver icon in the panel at the top of the desktop and select "Reorientation" in the popup menu, then select the orientation mode required (see the INSTRUCTION note at the end of this paragraph). NOTE: The orientation operation can also be activated using the related key at the top of the Function Key panel on the whiteboard. This function is used to tune the whiteboard for the image projected on it. Clicking with the mouse left button on "Re-orientation", a popup window appears. [. . . ] ⷠGenerally speaking, the image can be adjusted by using a remote control device or by correcting the height of the projector. What type of projector must be used with the Interactive Whiteboard?The projector must satisfy the three following requisites. For the precise amount, the room size must be taken into account. [. . . ]