User manual OLYMPUS C-700 ULTRA ZOOM

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] If you cannot insert the plug into the wall outlet, pull it out, reverse it, and then reinsert it. If the plug still fails to fit, contact an electrician and have the receptacle replaced. Protecting the Power Cord -- The power supply cord should be placed so it will not be walked on. Never put a heavy object on the power cord or wrap it around the leg of a table or chair. Keep the area around the power cord connection points, at the power outlet, and at the product connection, free of all AC adapter or accessory power cords. Lightning -- If a lightning storm occurs while using a specified AC adapter, remove it from the wall outlet immediately. To avoid damage from unexpected power surges, always unplug the AC adapter from the power outlet and disconnect it from the camera when the camera is not in use. Overloading -- Never overload wall outlets, extension cords, power strips, or other power connection points with too many plugs. Foreign Objects, Liquid Spillage -- To avoid personal injury caused by fire or electrical shock from contact with internal high voltage points, never insert a metal object into the product. Avoid using the product where there is a danger of spillage. Heat -- Never use or store this product near any heat source such as a radiator, heat register, stove, or any type of equipment or appliance that generates heat, including stereo amplifiers. Follow the steps, and attach the strap correctly. Olympus is not responsible for any damages resulting from the strap coming loose due to incorrect attachment. 11 CHARGING THE BATTERY The battery is not fully charged at the time of purchase. Charge the battery fully with the BCM-2 charger before use. 1 2 Connect the power cable. BCM-2 battery charger Power cable AC wall outlet En Insert the battery into the charger. Remove the protection cap. mark Protection cap Charging indicator mark TIPS The BLM-1 battery usually takes approximately 5 hours to charge. Meaning of the charging indicator: Lit red : Charging Lit green : Charging complete Blinking red : Charging error Note This camera uses one Olympus BLM-1 lithium ion battery. Attach the protection cap when transporting or storing the battery. The charger can be used within the range of AC 100 V to AC 240 V (50/60 Hz). When using the charger abroad, you may need a plug adapter to convert the plug to the shape of the AC wall outlet. For details, ask at your local electrical shop or travel agent. Index area You can use this space to write the contents of the card. Contacts The part where the data transferred from the camera enters the card. Note This camera may not recognize a non-Olympus card or a card that was formatted on another device (e. g. Make sure to format the card on this camera before use. Do not push the card in with a pen or similar hard or pointed object. [. . . ] If it is pressed forcefully, the camera may move causing the pictures to blur. Never open the battery compartment cover, remove the battery or disconnect the AC adapter while the card access lamp is blinking. Doing so could destroy stored pictures or prevent storage of pictures you have just taken. Recorded pictures are saved on the card regardless of whether the camera is turned off or the battery is replaced or removed. [. . . ]