User manual OLYMPUS PPO-E04

[. . . ] Do not combine this product with an inapplicable lens. When this product is used with the ZUIKO DIGITAL ED 7-14mm lens, the separately available PER-E02 Underwater Extension Ring must also be used. To ensure correct and safe use of this product, always use it as described in this instruction manual. unauthorized reproduction is strictly prohibited. [. . . ] Using the clamping screw securing wrench provided with the PPO-E04, loosen the four lens hood clamping screws on the PPO-E04. Adjust the hood until the image in the pickup finder is not cut off. Set the lens hood to the position where the image is not cut off. Tighten the lens hood clamping screws to clamp the lens hood in that position. Lens hood Clamping screw securing wrench Screw Pickup finder image Cutoff Screw Loosen screws using the wrench. Cutoff Image without cutoff Turn the lens hood to adjust the position. E-4 5 Dismounting the PPO-E04 1) When the PPO-E04 is mounted directly on the PT-E series case (When using the ZUIKO DIGITAL ED 8mm Fisheye lens) If any water is on the product, wipe it completely away and make sure that the product is dry. Holding the PT-E series case firmly with one hand, loosen the PPO-E04 by turning it about 90 degrees counterclockwise. If the PPO-E04 is attached too tightly to turn, wrap it with a piece of rubber or similar non-slip material. After loosening the PPO-E04, point its lens downward and turn it further counterclockwise until it is separated from the PT-E series case. Be careful not to drop the PPO-E04 or PT-E series case. CAUTION: When the PPO-E04 is removed from the PT-E series case, water drops on the O-rings may splash on the lens or camera. If this happens, wipe the water drops away from the lens and camera with a dry cloth. Make sure that all of the parts are completely dry before dismounting. E-5 2) When the PPO-E04 is combined with the PER-E02 Extension Ring (When using the ZUIKO DIGITAL ED 7-14mm lens) If any water is on the product, wipe it completely away and make sure that the product is dry. Holding the PT-E series case firmly with one hand, loosen the PPO-E04 from the PER-E02 extension ring by turning the PPO-E04 about 90 degrees counterclockwise. If the PPO-E04 is screwed in too tight, wrap it with a piece of rubber or other slip-resistant material. After loosening the PPO-E04, position it so that its lens points down and turn it further counterclockwise until it separates from the extension ring. Be careful not to drop the PPO-E04, PER-E02 extension ring or PT-E series case. Holding the PT-E series case firmly with one hand, loosen the PER-E02 by turning it about 90 degrees counterclockwise. If the PER-E02 is screwed in too tight, wrap it with a piece of rubber or other slip-resistant material. After loosening the PER-E02, point its lens down and turn it further counterclockwise until it is separated from the PT-E series case. [. . . ] To apply grease to each O-ring, squeeze a drop of grease about the size of a grain onto your finger and lightly rub the entire circumference of the O-ring to spread the grease thinly and evenly. 935 g Applicable case Applicable lens Main materials Main body Lens O-rings Front cap Rear cap Withstanding pressure Dimensions Weight Note) We reserve the right to change the external appearance and specifications without notice. 10 Consumable Items This product uses the following consumable items. 1-888-553-4448 (Toll-free) Our phone customer support is available from 8 am to 10 pm (Monday to Friday) ET E-Mail: distec@olympus. [. . . ]