User manual OLYMPUS PT-042

[. . . ] Q11: A11: Q12: PT-042 A12: 1 PT-042 POL-042 PT-042 2 PSOLG-1/2/3 3 SILCA-5S 5 4 PFUD-07 Jp JP 37 Jp PT-042 1020/Stylus 1020/1010/Stylus 1010 40m 62mm 138mm × 100mm ×104mm 455g JP 38 En Thank you for buying the Underwater Case PT-042. Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. Wrong use may cause damage to the camera inside the Case due to water leakage, and repair may not be possible. [. . . ] CAUTION: Hairs, fibers, and other narrow items are not very apparent, but they may cause entry of water. In addition, pay special attention to breaks and cracks on the Case. EN 21 Final test (water leakage test) The final test after loading the camera is explained below. This is the only way to eliminate worry about possible entry of water!It can be performed easily in a water tank or a bathtub. The required time is about five minutes. En 1 Simple water immersion test Place the Case slowly into the water. Explanatory image Hints As the Case is transparent, waterdrops entering into it can be confirmed easily. In case of trouble with the O-ring, three seconds are enough for water to enter. Are there air bubbles coming out between the lids?Remove the Case from the water and check that no water has accumulated at the bottom of the Case. Do not perform any operation yet, but just observe. Remove the Case from the water and check that no water has accumulated at the bottom of the Case. 2 At first, immerse the Case for only three seconds. 3 Check that no water has entered into the Case. 4 Next, immerse the Case for 30 seconds. 5 Check that no water has entered into the Case. Try operation of the all buttons, levers and dials. If there is still no entry of water, everything is OK!As the inside can be seen, the inspection for entry of water also can be made easily!* The PT-042 is not provided with a balance weight. Taking Pictures Under Water How to use the hand strap Pass your hand through the hand strap provided and adjust the length with the stop button. [. . . ] Replace the O-ring immediately with a new one if it shows signs of damage, crack or loss of elasticity. Q10: What are the important points for Case maintenance?A10: Pay special attention to the following items. 1 Never use the following chemicals for cleaning, corrosion protection, defogging, repair or other purposes. [. . . ]