User manual OLYMPUS PT-046

[. . . ] 5mm×99mm×78mm 305g Jp PT-046 O POL-041 SILCA-5S PSOLG-2 PRLC-11 PSOLG-1PSOLG-3 PWT-030 JP 27 MEMO En Thank you for buying the Underwater Case PT-046 (hereinafter Case). Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. Wrong use may cause damage to the camera inside the Case due to water leakage, and repair may not be possible. [. . . ] When a digital camera is loaded without removing the strap, the strap may get caught between the Case lids and may cause water leakage. EN 13 Open the Case 1 Slide and hold the slide lock towards the arrow direction (1 of figure below) and turn the open/close dial counter clockwise (2 of figure below). 2 Turn the open/close dial to the position where it cannot be turned further. En 1 Slide lock 2 Open Open/close dial CAUTION: Do not exert too much force while turning the open/close dial. EN 14 Load the digital camera 1 Confirm that the digital camera is OFF. 2 Gently insert the digital camera into the Case. 3 Insert a silica gel bag (1g) between the bottom of the digital camera and the Case. The silica gel bag provided for prevention of fogging. En 2 3 CAUTION: The silica gel bag will be caught when the Case is sealed and water leakage will occur. Once silica gel has been used, the moisture absorption performance will be impaired. Always replace the silica gel when the Case is opened and closed. Make sure the camera is loaded properly Check the following points before sealing the Case. Is silica gel inserted all the way at the specified location? Is the O-ring attached properly to the opening on the Case? Is there any dirt or foreign matter on the O-ring or the O-ring contact surface on the front lid?For details of the maintenance, see "6. EN 15 Seal the Case 1 Close the rear lid of the Case gently. The Case is sealed when the dial is turned 180 degrees. en Close CAUTION: · If the open/close dial is not fully turned, the Case will not be sealed. Close the rear lid of the Case so that the lens cap strap doesn't catch. if it catches , water leaks may result. Check the operation of the loaded camera After sealing the Case, check that the camera operations normally. [. . . ] EN 24 How to Apply Grease to the O-ring Apply the exclusive lubricant to each O-ring. Make sure that your fingers and the O-ring are free of dirt, and squeeze about 5 mm of lubricant onto a finger. ) Apply the lubricant with three fingers and spread it over the ring. Be careful not to use force as this may stretch the O-ring. [. . . ]