User manual OLYMPUS PT-055

[. . . ] VM9754TA-01-01-PT-055-Inst-EN. book Page 2 Monday, January 7, 2013 2:53 PM EN Thank you for buying the Underwater Case PT-055 (hereinafter Case). Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. Wrong use may cause damage to the camera inside the Case due to water leakage, and repair may not be possible. [. . . ] For details of the functions, refer to the instruction manual for the digital camera. EN 10 VM9754TA-01-01-PT-055-Inst-EN. book Page 11 Monday, January 7, 2013 2:53 PM Using the accesories Install the strap Install the strap on the Case body. Installation illustration Installation completed EN Hand strap Hand strap ring How to use the hand strap Pass your hand through the hand strap and adjust the length with the stop button. stop button EN 11 VM9754TA-01-01-PT-055-Inst-EN. book Page 12 Monday, January 7, 2013 2:53 PM Installation and removal of the LCD hood Installation Fit the LCD hood as shown in the figure into the guides above and below the LCD monitor window one after the other. Removal Remove the LCD hood from the guides above and below the LCD monitor window one after the other by widening the LCD hood. EN Guides 1 1 2 Installation 2 Removal Mounting and removing the lens cap Fit the lens cap onto the lens ring as shown in the figure. when closing the Case Perform the test after the above causes have been eliminated. CAUTION: If a leak is detected in normal handling, do not use the Case and contact Olympus. EN 14 VM9754TA-01-01-PT-055-Inst-EN. book Page 15 Monday, January 7, 2013 2:53 PM 3. Install the digital camera Check the digital camera Check the digital camera before loading it in the Case. EN 1. Battery Confirmation The flash is used very frequently during underwater shooting. Before diving, make sure that you have enough remaining battery power. 2. Confirmation of the Remaining Number of Pictures to be Taken Confirm that the image storage has a sufficient remaining number of pictures to be taken. 3. Remove the hand strap from the digital camera. When a digital camera is loaded without removing the strap, the strap may get caught between the Case lids and may cause water leakage. Open the Case 1 Slide the lock knob towards the arrow direction (1 of figure below). 2 Slide and hold the slide lock towards the arrow direction (2 of figure below) and turn the open/close dial counter clockwise (3 of figure below). 3 Turn the open/close dial to the position where it cannot be turned further. 4 Open the rear lid of the Case gently. Slide lock Lock knob 2 3 Open 1 Open/close dial CAUTION: Do not exert too much force while turning the open/close dial. Doing so may damage the dial. EN 15 VM9754TA-01-01-PT-055-Inst-EN. book Page 16 Monday, January 7, 2013 2:53 PM Load the digital camera 1 Confirm that the digital camera is OFF. 2 Gently insert the digital camera into the Case. 3 Insert 2 piling up silica gel bags (1g) between the bottom of the digital camera and the Case. The silica gel bag provided for prevention of fogging. 2 EN 3 CAUTION: • The silica gel bag will be caught when the Case is sealed and water leakage will occur. • Once silica gel has been used, the moisture absorption performance will be impaired. Always replace the silica gel when the Case is opened and closed. Make sure the camera is loaded properly Check the following points before sealing the Case. • Is the digital camera loaded properly?• Is silica gel inserted all the way at the specified location?• Is the O-ring attached properly to the opening on the Case? [. . . ] • Never use alcohol, thinner, benzene or similar solvents or chemical detergents to clean the O-ring. When such chemicals are used, the O-ring may be damaged or its deterioration will be accelerated. EN 24 VM9754TA-01-01-PT-055-Inst-EN. book Page 25 Monday, January 7, 2013 2:53 PM How to Apply Grease to the O-ring Apply the exclusive lubricant to each O-ring. Make sure that your fingers and the O-ring are free of dirt, and squeeze about 5 mm of lubricant onto a finger. (5 mm is the most appropriate amount. ) Apply the lubricant with three fingers and spread it over the ring. [. . . ]