User manual OLYMPUS PT-EP05L

[. . . ] PT-EP05L/06L Instruction Manual PT-EP05L/06L http://www. olympus. com/ Jp En Fr De Sp Cs Kr ©2011 Printed in China VR808501 Instruction Manual Mode d'emploi Bedienungsanleitung Manual de instrucciones Thank you for buying the Underwater Case PT-EP05L/06L (hereinafter Case). Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. Wrong usage may cause damage to the camera inside the Case due to water leakage, and repair may not be possible. [. . . ] · Forgetting to install the O-ring · Part of an O-ring or an entire O-ring is outside the specified groove. · O-ring damage, cracks, deterioration or deformation · Sand, fibers, hair or other foreign matter sticking to the O-ring, the O-ring groove or the O-ring contact surface. · Damage to an O-ring groove or O-ring contact surface. · Attached strap or silica gel getting caught when closing the Case. Perform the test after the above causes have been eliminated. CAUTION: If the advance test should show water leakage with normal handling, stop using the Case and contact your dealer or an Olympus service station. En EN 11 3. Loading the digital camera Check the digital camera Check the digital camera before loading it in the Case. 1. Battery confirmation It is impossible to change the batteries when using the Case. Make sure that you have sufficient remaining battery capacity before use. 2. Check the remaining number of pictures Check that the image storage medium has enough room for the number of pictures you want to take. 3. Remove the strap, lens cap and filter from the digital camera. If the digital camera is loaded without removing the strap, lens cap and the Case cannot be sealed properly and water leakage may be caused. 4. When using PT-EP05L, insert the back monitor of the camera. Attach the zoom gear (optional) and the antireflective ring. Antireflective ring POSR-EP03 cannot be used. Zoom gear M. ZUIKO DIGITAL ED 14-42mm II M. ZUIKO DIGITAL ED 14-42mm II R PPZR-EP02 Antireflective ring POSR-EP05 (supplied) En EN 12 Open the Case 1 Slide and hold the slide lock towards the arrow direction (1) and turn the open/close dial clockwise (2). 2 Open the rear lid of the Case gently. 1 Slide lock 2 CAUTION: Do not apply too much force while turning the open/close dial. Doing so may damage the dial. Attach the flash to the camera and raise the light emitting part Attach the flash supplied with the camera. Make sure to raise the light emitting part. En EN 13 Insert the batteries for the light Open the battery lid. Insert 2 AAA batteries on the ribbon. Pay attention to the battery direction. Close the battery lid. En EN 14 Load the digital camera 1 Confirm that the digital camera is OFF. 2 Gently load the digital camera into the Case. 3 Insert a silica gel bag (1g) between the bottom of the digital camera and the Case. The silica gel bag provided for prevention of fogging. 2 3 CAUTION: · If the silica gel bag is caught when the Case is sealed, water leakage will occur. [. . . ] · When the O-ring is checked with the fingertips, take care not to stretch the O-ring. · Never use alcohol, thinner, benzene or similar solvents or chemicals detergents to clean the O-ring. When such chemicals are used, it is likely that the O-ring will be damaged or that its deterioration will be accelerated. En Install the O-ring Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the O-ring, and fit the O-ring into the groove. At this time, confirm that the O-ring does not stick out from the groove. [. . . ]