User manual OMRON E32-L25T DATASHEET

[. . . ] Fluid level sensor (fiber pipe type) E32-L25T E32-L25T For installation of thin pipe (thickness of 10 mm) that can be used even in combustible atmospheres Easy post-installation on unit or pipe using band. [. . . ] Polycarbonate Plastic (polyethylene coating) IEC 60529 IP50 Approx. 10 g Band, anti-reflection sheet, fiber cutter Protective structure Weight (Packed state) Accessories *1. When using an opaque fluid, test detection with the unit before using. E32-L25T A-365 Principle of operation No fluid If no detection fluid, light state. Pipe Fluid If there is detection fluid, set so that dark state is effective. Pipe Emitter Receiver Emitter Receiver Precautions Correct Use Installation · If only the Fiber Unit is installed, proceed according to the following basic procedure. Pipe Binding band E32-L25T · Detection of level differences to a minimum of 4 mm is possible with the following installations. Pipe Binding band · When securing with the band, take care that the fiber is not deformed. · If an opaque pipe is used, this may result into incorrect operation. · Water drops, air bubbles, or clouding in the pipe may cause incorrect operation. · If the background exerts an effect, use the anti-reflection sheet (accessory) (see the diagram below). The anti-reflection sheet also serves to prevent shifting due to fiber unit vibration. Antireflection sheet Binding band Pipe E32-L25T 4mm E32-L25T Binding band E32-L25T · Do not expose the fiber unit to undo forces such as pulling or compression (no more than 0. 1 Nm). · The bending radius of the fiber unit should be no less than the allowed bending radius (both rated and performance). Miscellaneous Polycarbonate is used in the case. [. . . ] E03E-EN-01 In the interest of product improvement, specifications are subject to change without notice. A-366 Advanced Photoelectric Sensors [. . . ]