User manual OMRON E3S-LS3 DATASHEET

[. . . ] Printed Circuit Board Sensor E3S-LS3 E3S-LS3 Printed circuit board sensor capable of stable detection without being affected by holes or notches. · Suitable for incorporation in devices (E3S-LS3@). [. . . ] Operating: - to 55° C (with no icing or condensation) 10 Operating:35% to 85% (with no condensation) 20 M min. (at 500 VDC) between charged parts and the case 1, 000 VAC at 50/60 Hz for 1 minute between charged parts and the case 10 to 55 Hz with a 1. 5-mm double amplitude for 2 hrs each in X, Y and Z directions 500 m/s2, 3 times each in X, Y and Z directions IEC60529 IP40 Pre-wired (standard length: 2 m)/Pre-wired M8 connector (standard length: 0. 3 m) Operation indicator (orange) Pre-wired models: Approx. 45 g ABS Acrylic Instruction sheet, M3 screws, Case Lens White art paper 20 to 35 mm Limited reflective E3S-LS3PT E3S-LS3@W 10 to 60 mm 15 to 50 mm E3S-LS3PWT Light source (wave length) Power supply voltage Current consumption Control output Response time Timer function Ambient illuminance Ambient temperature Ambient humidity Insulation resistance Dielectric strength Vibration resistance Shock resistance Protective structure Connection method Indicators Weight (Packed state) Material Accessories A-146 Standard Photoelectric Sensors Characteristic data (typical) Sensing Distance vs. Materials Sensing distance (mm) Operating Range (Left and Right) Sensing object: White paper, 100 x 100 mm 15 Operating Range (Up and Down) -15 -12 Y X 80 70 60 Sensing object: White paper, 100 x 100 mm E3S-LS3@W (T) 12 X Y 9 6 Distance Y (mm) E3S-LS3PW (T) -9 -6 E3S-LS3PW (T) E3S-LS3P (T) Distance Y (mm) 50 40 30 20 3 0 -3 -6 -9 0 10 E3S-LS3P (T) -3 0 3 6 9 12 15 0 10 20 30 40 50 60 70 20 30 40 50 60 70 10 0 -12 White paper Black paper SUS PCB with Black green resist PCB Material -15 Distance X (mm) Distance X (mm) Output vs. Sensing Distance 35 30 Incident light output gain 25 Spot diameter (mm) 10 Direction L d L 20 15 Operating level 1 E3S-LS3P (T) E3S-LS3PW (T) 10 Direction d 5 0. 1 0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 Distance (mm) 0 10 20 30 40 50 Distance (mm) 60 70 Output Circuit Diagram NPN output (PNP output will be available soon) Model Operating status of output transistor Timing chart Output circuit Brown 12 to 24 VDC Incident Interrupted Operation indicator ON (orange) OFF ON Output transistor OFF Operation indicator (orange) Main circuit Z Blue 0V Incident light Black OUT Load E3S-LSN3 E3S-LS3NW E3S-LS3P E3S-LS3PW Light ON No Incident light Operation indicator ON (orange) OFF Output transistor ON OFF Incident light E3S-LS3PT E3S-LS3PWT No Incident light Operation indicator ON (orange) OFF Output transistor ON OFF T T: Off-delay timer (0. 1 to 1. 0 s) E3S-LS3 A-147 E3S-LS3 E3S-LS3P (T) Dimensions (Unit: mm) Note: All units are in millimeters unless otherwise indicated. E3S-LS3N E3S-LS3NW Operation indicator (orange) 10 16. 5 34 3 "Vinyl-insulated round cable of 4 dia. 3 cores conductor cross-sectional area: 0. 12mm2; insulation diameter: 1. 2 mmStandard length: 2 m" 12. 3 28 Emitter 28 Mounting Holes Two, 3 dia. 19 5. 3 Two, M3 mounting holes Receiver E3S-LS3@(T)(-M5J/-M3J) E3S-LS3@W(T)(-M5J/-M3J) Operation Indicator Timer Adjuster (see note) Pre-wired M8 3-pin connector (-M5J) M8 1 4 3 10 14. 2 8. 5 dia. [. . . ] E223-E2-01-X In the interest of product improvement, specifications are subject to change without notice. A-148 Standard Photoelectric Sensors [. . . ]