User manual ONE FOR ALL 1280

[. . . ] If your brand is not listed at all please try the Code Search. Make sure your equipment is switched on. TV key) corresponding to the device you wish to control (e. [. . . ] TV key) corresponding to the device you wish to Press and hold down the SETUP key until the red LED underneath the POWER key blinks twice (the red LED will blink once then twice). now press CH+ over and over , Until your Television turns off (everytime you press the CH+ key the ONE FOR ALL will send out a POWER signal from the next code contained in the memory). You may have to press this key many times (up to 150 times) so please be patient. As soon as your television turns off, press the SETUP key to store the code. learning (copy) Your One For All remote control can learn any function from any other working remote control. To do this, firstly make sure you have all your original remote controls to hand, and that they have working batteries in. To learn functions, the original remote should be approximately 3cm from the OFA remote, pointing towards it as shown below: Press and hold down the SETUP key until the red LED underneath the POWER key blinks twice (the red LED will blink once then twice). Press and release the key you want to learn a function onto (for example Press and release the corresponding key on the original remote, for example Power. The red LED will blink twice to indicate the key has been learned correctly. Repeat steps 4 and 5 for each key you want to learn ­ remember you can Learn from multiple remotes, but only one function per key. When you learned all the functions you require, press and hold the SETUP Key until the red LED blinks twice. If the red LED shows one long blink at step 6, the function was not learned correctly, please try again from step 4. If you find one or more keys don't work properly after set up, you can re-enter the learning mode at any time by repeating the procedure from step 1. How to delete a learned function to obtain the original function?Press and hold down the SETUP key until the red LED underneath The POWER key blinks twice (the red LED will blink once then twice). This feature gives you the possibility to set the Volume (VOL+, VOL- and Mute) to always control a certain device (e. [. . . ] Når du skal konfigurere koden for en annen enhet, følger du instruksjonene over, men trykker på den passende enhetsknappen i stedet for TV i trinn 2. For å gjøre dette må du først sørge for at du har alle de originale fjernkontrollene fremme, og at de ikke er tomme for batteri. Sökmetoden gör det möjligt för dig att hitta koden till din apparat genom att söka igenom alla koder som finns i minnet till din ONE FOR ALL. [. . . ]