User manual ONE FOR ALL KAMELEON 8-DEVICE

[. . . ] OFA Kameleon UG 5/8/03 3:22 PM Page 1 8-Device Universal Remote Control URC-9960 User's Guide OFA Kameleon UG 5/8/03 3:22 PM Page 2 KAMELEON 8-DEVICE REMOTE TABLE OF CONTENTS Introduction . 16 Programming A Favorite Channel Macro . 16 Programming A Master Power Macro In The Home Theater Mode . 19 Deleting All Learned Keys In A Specific Mode . [. . . ] Now, if you aim the remote control at the devices selected in step 4 and press the programmed Macro Key once, the TV will turn on and tune to channel 3. Then, the Cable Box will turn on, and tune to channel 071. 1. Press and hold SETUP until the two bottom IR segments flash twice. The Program Keys will appear as SETUP flashes repeatedly. PROGRAMMING A MASTER POWER MACRO IN THE HOME THEATER MODE A macro can be programmed onto the POWER key to turn on or off as many as seven Home Theater devices. NOTE: This following example assumes the Home Theater system contains a Satellite Receiver, a DVD Player, an Audio Receiver, and a TV. 2. The Macro programming screen will appear (as shown above right): 16 Using Macros OFA Kameleon UG 5/8/03 3:23 PM Page 17 USER'S GUIDE 1. Press and hold SETUP until the two bottom IR segments flash twice. The Program Keys will appear as SETUP flashes repeatedly. CLEARING A MACRO 1. Press and hold SETUP until the two bottom IR segments flash twice. The Program Keys will appear as SETUP flashes repeatedly. 2. The Macro programming screen will appear: 2. The Macro programming screen will appear: 3. Press POWER once. The last-selected device menu screen, including HOME, will be displayed. For this example, press CBL/SAT once, followed by POWER once. Next, press DVD once, followed by POWER once. Then press AUDIO once, followed by POWER once. Finally, press TV once, followed by POWER once. , and then the Home Theater key once. To save the power macro, press and hold SETUP until the two bottom IR segments flash twice. The display will return to the last-selected device menu screen. To test the power macro, first make sure all home theater devices selected in step 4 are turned on. Aim the remote control at the devices and press the Home Theater key once, followed by POWER once. The devices should turn off in this order: Satellite Receiver, DVD Player, Audio Receiver, and TV. To turn on the devices on again in the same order as above, press POWER once. 3. Select the Macro Key to be cleared and press it once. [. . . ] This limited warranty is valid only on Universal Electronics product purchased and used in the United States of America or Canada, and does not apply to products used for industrial or commercial purpose. The limited warranty does not cover damage or failure caused by products or services not supplied by Universal Electronics , or which result from accident, misuse, abuse, neglect, mishandling, misapplication, faulty installation, set-up adjustment, improper maintenance, alteration, maladjustment of consumer controls, modifications, commercial use, or that is attributable to acts of God. There are no express warranties except as listed above. Universal Electronics SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF WARRANTY. ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE WARRANTY PERIOD SET FORTH ABOVE. [. . . ]