User manual ONE FOR ALL SV-9510

[. . . ] 3-6 Copier . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6 Inside the Copier . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8 Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-9 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] E. g. : A3L and A4C Making Copies from Originals of Mixed Sizes 1 Slide the front adjustable Document Guide Plate to the front of the copier. 2 Load the originals face up in the Document Feeder Tray so that their rear edges are in correct alignment with the Document Guide Plate. 4-4 Konica7115_7118. book Page 5 Tuesday, October 16, 2001 10:51 AM Loading Originals 4 3 Press the front adjustable Document Guide Plate tightly up against the front edges of the originals. ?Is the stack of originals neat? The maximum number of originals that can be loaded is 50. Be sure that the top level of the original stack does not exceed the Ä marking. Be sure that the Document Guide Plates touch both the front and rear edges of the original stack. If they are not pressed snugly against the original stack, skewed feeding could result. 4 Press the [ORIGINAL] key to light the MIXED ORIGINAL lamp. 5 Press the [APS/AMS] key to light the APS lamp. 6 Press the [START] key to start feeding and copying the originals from the top page. 4-5 Konica7115_7118. book Page 6 Tuesday, October 16, 2001 10:51 AM 4 4. 3 Loading Originals Place the Original on the Original Glass The method for positioning the original differs depending on the type of original being used. Be sure to use the appropriate method that best suits the type of original. Refer to p. 4-2 for information on using the Automatic Document Feeder. Precautions for Placing the Original on the Original Glass Care should be used when positioning the following types of originals. An original of a nonstandard size: G The copier is unable to detect the original size automatically, meaning that neither APS nor AMS can be used. Therefore, use the [PAPER SIZE] key to select the paper size, or the [RE] key to select the zoom ratio. (p. 5-11) A highly transparent original (OHP transparencies, translucent paper, etc. ): G Place a blank sheet of paper of the same size over the original. Details: OHP transparencies Cards and postcards Plain paper If plain paper is set in User's Choice, the "1" mark will not be displayed even if cards or postcards, or OHP transparencies, are loaded in the tray. 5-4 Konica7115_7118. book Page 5 Tuesday, October 16, 2001 10:51 AM Making Copies 5 5. 3 Feeding Paper Manually Paper can be fed manually through the Bypass Tray if you want to copy onto paper that is not loaded in any tray, or if you want to copy onto special paper, such as OHP transparencies, postcards, or cards. Types of paper that can be fed through the Bypass Tray G G G Plain paper (weighing 60 g/m2 to 90 g/m2) Recycled paper (weighing 60 g/m2 to 90 g/m2) Special paper: Card (weighing 91 g/m2 to 157 g/m2), OHP transparencies, postcards, and labels Maximum size: 297 mm x 432 mm Minimum size: 90 mm x 140 mm Sizes of paper that can be fed through the Bypass Tray G G Note Insert one sheet of paper at a time when using the Manual Bypass Tray to make a copy. If the optional Multiple Bypass is mounted, the Bypass Tray can hold up to 50 sheets of paper, or 20 sheets of cards, postcards, or OHP transparencies. 5-5 Konica7115_7118. book Page 6 Tuesday, October 16, 2001 10:51 AM 5 Making Copies by Using the Bypass Tray <Manual Bypass Tray> Making Copies 1 Position the original. Original Loading (p. 4-1) 2 Slide the Paper Guides to the size of the paper. Load a sheet of paper so that the front side of the paper faces down. At this time, gently insert the paper until it is stopped. Note that the Bypass Tray location indicator on the control panel lights. Do youother than plaintype of paper paper? To use cards, postcards, or OHP transparencies, first change the type of paper selecting User's Choice. Refer to "Paper Type (Bypass Tray)" (p. 7-9). When loading cards or postcard, be sure to smooth out any curl in the paper. 3 Press the [BYPASS TRAY] key until the size of the paper loaded lights. ? If the paper used is of custom size, its size must be input. Refer to the "Custom Size Input (Bypass Tray)" procedure that follows. (p. 5-9) Do you know which FLS size has been set? [. . . ] height 22 mm) · Special paper: 10 sheets <Lower Copy Tray> · Plain paper (80g/m2), recycled paper: A4 150 sheets, sizes other than A4 75 sheets · Special paper: 20 sheets 63 W or less Capacity Power Consumption Multiple Bypass Tray MT-102 Specifications Kinds of Paper Plain paper: (60g/m2 to 90 g/m2), recycled paper Special paper: card (91 g/m2 to 157 g/m2), OHP transparencies, postcards, labels Width: 90 mm to 297 mm Length: 140 mm to 432 mm Plain paper, recycled paper: 50 sheets Special paper: 20 sheets 9 W or less Width Max. : 436 mm Depth: 489 mm Height: 137 mm Approx. 2. 7 kg Paper Size Capacity Power Consumption Dimensions Weight 10-4 Chapter10. fm Page 5 Tuesday, October 16, 2001 1:16 PM Appendix 10 10. 2 Care of the Copier Cleaning Turn OFF the copier before cleaning it. Housing Cover Wipe the surface of the housing cover with a soft cloth dampened with a mild household detergent. Original Pad Wipe the surface of the Original Pad clean with a soft cloth dampened with alcohol. Platen Glass Wipe the surface of the Platen Glass clean with a soft, dry cloth. Control Panel Wipe the surface of the control panel clean with a soft, dry cloth. Do you know if detergent can be used for cleaning? ? NEVER use household detergent or glass cleaner, as a damaged control key could result. 10-5 Konica7115_7118. book Page 6 Tuesday, October 16, 2001 10:51 AM 10 10. 3 Function Combination Table Function Combination Table Appendix Function Set Last Conditions for Combined Functions Code Description The functions can be combined. [. . . ]