User manual ONE FOR ALL URC-4220

[. . . ] Moreover, its sophisticated technology will allow you to consolidate your original home entertainment remote controls into one easy-to-use product. Intuitive buttons to allow easy access to functions and menus on your DVD player, PVR (or DVR), and Cable/Satellite devices · direct code setup for easy device programming · Step-and-Set code search and Code Verification for an alternate way to program devices · Power Macro for master on/off control of all of your equipment with a single keystroke · Color-coded keys to quickly locate popular functions · The URC-4220 remote control requires two (2) new AAA alkaline batteries (not included) and some easy programming to control your devices. for best results , please read and perform all instructions listed here. Also, keep this guide for future reference. [. . . ] For example, to find out which code is operating your TV: 1. Press and hold SET until the LED (red light) blinks twice, then release SET. To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (e. , three blinks = 3) and write down the number in the leftmost box in the TV code boxes on page 8. Repeat step 4 (on the previous page) three more times for remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. write down the code digits in the remaining TV code boxes on page 8. To check for codes of other devices, repeat steps 1 through 5 (starting on the previous page), but substitute the appropriate device key for each device you are checking. In its default state, the POWER key on the One For All 4 Device Universal Remote Control will individually power your home entertainment devices on or off. However, you can also program a Master Power Macro onto the POWER key that will sequentially turn on or off all the devices with a single key press. Press and hold SET until the LED (red light) blinks twice, then release SET. For the first device you want in the power-on sequence, press its device key (e. Repeat step 3 up to three more times to add desired devices to the power-on sequence (e. To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET. After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequentially turn on (or off) your devices. NOTE: When POWER is pressed for less than 2 seconds, a power command will only be sent to the currently-selected device. This allows you to still individually power devices on or off. Devices will turn on (or off) according to your programmed sequence. NOTE: The currently-selected device will always turn on or off first, followed by the remaining programmed sequence. After the master power sequence has been completed, the remote control will be set to control the first powered-on device. NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s). [. . . ] Enter 9 - 9 - 3 and then press VOL - once. If desired, repeat steps 1 through 3 (of this section) for each device that you want volume to be unlocked. Now, after you select a device that has volume unlocked (e. , DVD), pressing VOL +, VOL -, or MUTE will control the device's volume only in its own mode. [. . . ]