User manual ONEFORALL URC 7556

[. . . ] CODE BLINK OUT (To find out which code is currently programmed) QUICK CODE REFERENCE THE LEARNING FEATURE (How to copy functions from your original working remote onto the ONE FOR ALL 5) OPERATIONAL RESET EXTRA FEATURES · Key Magic (How to program missing functions) · Your ONE FOR ALL 5 can operate five devices: TV : Television VCR : Video Recorder SAT : Satellite Receiver or Cable Converter DVD : DVD Player AMP : Amplifier / Tuner Also, what makes the ONE FOR ALL 5 even more unique is the "Learning" feature, which allows you to customise any of the special functions of your original remote control onto the keypad of your new ONE FOR ALL 5. The following pages explain in simple steps how to customise the ONE FOR ALL 5 to your devices. You may need this guide again in the future, so please be sure to keep it. Your ONE FOR ALL 5 requires 4 new "AAA/LR03" alkaline batteries. [. . . ] Press and hold the MAGIC key until one of the device keys will blink twice. The red LED underneath the corresponding device key (depending on the device mode that was selected) will blink once then twice. press 9 7 5 (the device key will blink twice). Press the device key (on the ONE FOR ALL remote) to select the mode to which you want to copy the learned function (Example: TV key). Press the key (on the ONE FOR ALL remote) where you want to place the learned function (Example: "Radio" key). Press and hold the key (on your original remote) that you want to copy until the device key on the ONE FOR ALL blinks twice (Example: "mono/stereo" key). 7 If you want to copy other functions within the same mode, simply repeat steps 5 and 6 pressing the next key you want to copy by learning. 8 To exit the learning mode, press and hold MAGIC until the device key blinks twice. To access your learned function, press the appropriate device key first. Important notes: - During steps 2 - 7 (page 9), you have approximately 10 seconds to conduct each step. If there is a gap of more than 10 seconds between two steps, you will have to start again from step number 2. - If you learn a function on a key, the original ONE FOR ALL feature automatically becomes shifted. You can press MAGIC then the key to access it (this excludes the Channel and Volume keys). - The Learning feature is mode specific. Therefore you can place one learned feature per mode on the same key. - You can replace a learned function by placing another learned function on top. - Learning should not be done in direct sunlight or under incandescent lights. - Make sure you are using new batteries before following the instructions above. You can also learn a function on a key of the ONE FOR ALL without sacrificing the original ONE FOR ALL function. A Shifted Learning function can also be put on any key EXCEPT for the following: Device keys, MAGIC key, Number keys. to install a Shifted Learning function , simply follow steps 1-8 on the previous page. During step 5, press MAGIC once before you press the key where you are placing the learned function. [. . . ] If your Light Control kit is not responding well, try one of the other codes listed. To set up your HC Receiver to work with your remote, you will need to assign a number to it. This is a one-time process that will allow you to control individual lights separately if you purchase additional HC Receivers in the future. To assign a number to the plug, follow these steps: Plug the lamp into the HC Receiver, and plug the HC Receiver into the wall outlet. [. . . ]