User manual ONKYO D-205F

[. . . ] Connect the Right and Left speakers (as viewed from the listening position) to the amplifier's corresponding Right and Left speaker terminals. Before using this unit The speaker cabinet is made of wood and is therefore sensitive to extreme temperatures and humidity. Avoid placing the speaker systems in locations subjected to direct sunlight, or in smokey or in humid places, such as near an air conditioner, humidifier, bathroom, or kitchen. Doing so may result in damage to the speaker. Place the unit on a rigid, level surface. [. . . ] Otherwise, a short-circuit may occur, causing damage to the amplifier. Be sure to connect the speaker cables with correct polarity (connect the speaker's positive (+) and negative (­) binding posts with the amplifier's corresponding speaker terminals). Reversed polarity results in impaired bass-range reproduction, causing mislocalization of the sound image. Also, be sure to connect the Right and Left speakers with the amplifier's corresponding speaker terminals. Pull lightly on the speaker cables to ensure that they are connected firmly. Use with a TV set In general, Braun tubes used for color television sets, etc. are extremely sensitive and can be affected even by the magnetism of the earth. If a speaker system is used near them, therefore, discoloration or distortion of pictures will occur. To allow use with color television sets, etc. , this speaker system is provided with magnetic shielding. Even so, discoloration may still result, depending on the installation environment. If discoloration occurs, turn off the power of the television set, wait for 15 to 30 minutes and then turn it on again. This activates the self-demagnetizing function of the television set, improving the display condition. If discoloration persists even after performing this remedy, move the speaker apart from the television set. Discoloration may also be caused when a magnet or other magnetizing object exists near the television because of the combined effect. Attaching and detaching the speaker grilles This speaker system uses detachable grilles. Use the following method to attach or detach the grilles. While holding the bottom edge of the speaker grille with your both hands, pull it gently toward you to remove the bottom of the grille. In the same way, gently pull the upper edge of the speaker grille toward you to remove it from the main unit. To replace the grill, push the projections at the corners into the grille plug holes on the speaker cabinet. Removal Replacement Placement The sound quality a speaker system reproduces varies greatly depending on the construction and area of the room where it is installed, as well as the location and size of the furniture. For betterquality sound, observe the following precautions. Avoid placing the speaker system on an elevated object such as on concrete blocks. Instead, place it on a rigid floor surface with minimal vibration. [. . . ] Wipe the cabinet periodically with a dry, silicon-embedded or plain soft cloth. The covering may be cleaned with a soft cloth moistened with water and a mild soap. Avoid the use of furniture polishes or harsh cleansers. Use a soft brush or hand vacuum cleaner to remove dust and lint from the grille material. Specifications Model Type Impedance Maximum input power Output sound pressure level Frequency response Crossover frequency Cabinet capacity Speaker Dimensions Weight Accessory Others D-205F 2-way bass reflex 6 70 W 86 dB/W/m 50 Hz-35 kHz 1. 5 kHz 13. 3L Woofer: 12-cm cone Tweeter: 2. 5-cm dome 195 (W) x 800 (H) x 268 (D) mm (Overall dimensions) 10 kg 2. 5-m speaker cable (1) Instruction manual (1) Magnetic shielding V Specifications and appearance may subject to change for improvement without prior notice. [. . . ]