User manual ONKYO HT-R358

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] If no digital input signal is present, the corresponding analog input is used instead. pCM: Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indicator will flash and noise may also be produced. dTS: Only DTS (but not DTS-HD) format input signals will be heard. If the input signal is not DTS, the dts indicator will flash and there will be no sound. When “HDMI”, “COAXIAL” or “OPTICAL” is selected in the “Audio Selector” setting, you can then specify the signal type in “Fixed Mode”. Normally, the AV receiver detects the signal format automatically. However, if you experience either of the following issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS. € If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM. € If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS. Note • The setting will be reset to “Off” when you change the setting in the “Audio Selector” (➔ page 39). Hardware 1 2 3 4 5 6 Menu Hardware OSD ■ Volume OSD On Off Turn this setting on to display the volume level on the TV screen while it is adjusted. Remote ID ■ Remote ID 1, 2, or 3 When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from the other components, you can change its remote ID from “1”, to “2” or “3”. Note • If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller. Changing the remote controller’s ID 1 2 While holding down RECEIVER, press and hold down SETUP until the remote indicator lights (about 3 seconds). Use the number buttons to enter ID 1, 2, or 3. En-39 Advanced Operations Tuner ■ AM Freq Step 10kHz: 9kHz: Select the frequency step according to your area. For AM tuning to work properly, you must specify the AM frequency step used in your area. Note • When this setting is changed, all radio presets will be deleted. uP-A1 ■ UP-A1 ChargeMode Auto: Power feeding is interrupted when your iPod/iPhone is fully charged. On: Power feeding continues even if your iPod/iPhone is fully charged. [. . . ] With hollow walls, use a cable/pipe detector to check for any power cables or water pipes before making any holes. € Leave a gap of between 5 mm and 10 mm between the wall and the base of the screw head, as shown (We recommend that you consult a home installation professional). Thin rubber stoppers Keyhole slot for wall mounting 25 mm 30 mm Thick rubber stoppers SKF-558/SKR-558 Bottom of the SKC-391 En-2 Enjoying Home Cinema The Home Cinema means that you can enjoy surround sound with a real sense of movement in your own home — just like being in a movie theater or concert hall. A Front left and right speakers (SKF-558) They should be positioned facing the listener at about ear level, and equally spaced from the TV. [. . . ]