User manual ONKYO HT-RC160

[. . . ] Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 AV Receiver Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 HT-RC160 Turning On & First Time Setup . . . . . 37 Instruction Manual Basic Operations. . . . . . . . . . . . . . . . . . . . . . . . . 50 Using the Listening Modes . . . . . . . . 59 Advanced Setup . . . . . . . . . . . . . . . . . . . . . . . . . . 66 Zone 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 82 Controlling Other Components . . . . 86 Thank you for purchasing an Onkyo AV Receiver. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. Others. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 97 En WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] If the "Surr Back" Setting is set to "None" (page 67), this setting cannot be selected. This function can be set only if the "Subwoofer" setting is set to "Yes", and the "Front" setting is set to "Full Band". Speaker Distance This setting is set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 45). Here you can specify the distance from each speaker to the listening position so that the sound from each speaker arrives at the listener's ears as the sound designer intended. Unit feet: Distances can be set in feet. Range: 0. 3 to 9 meters in 0. 3-meter steps. Left, Front High Left, Center, Front High Right, Right, Surr Right, Surr Back R, Surr Back L, Surr Left, Subwoofer Specify the distance from the each speaker to your listening position. Note: Speakers that you set to "No" or "None" in the Speaker Configuration (page 67) cannot be selected. Notes: · The Center, Subwoofer and Front High distances can be set up to 5 ft. (1. 5 m) more or less than the Left distance. For example, if the Left distance is set to 20 ft. (6 m), the Center, Subwoofer, Front High Left and Front High Right distances can be set between 15 and 25 ft. · The Surround and Surround Back distances can be set up to 5 ft. For example, if the Left distance is set to 20 ft. (6 m), the Surr Right, Surr Left, Surr Back R, and Surr Back L distances can be set between 5 and 25 ft. (1. 5 and 7. 5 m). 68 Advanced Setup--Continued Level calibration This setting is set automatically by the Audyssey 2EQTM Room Correction and Speaker Setup function (see page 45). Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position. Left, Front High Left, Center, Front High Right, Right, Surr Right, Surr Back R, Surr Back L, Surr Left, Subwoofer The levels can be adjusted from ­12 to +12 dB in 1 dB steps (­15 to +12 dB for the subwoofer). Note: Speakers that you set to "No" or "None" in the "Speaker Configuration" (page 67) do not output the test tone. Note: The speakers cannot be calibrated while the output of the AV receiver is muted. Tip: If you're using a handheld sound level meter, adjust the level of each speaker so that it reads 75 dB SPL at the listening position, measured with C-weighting and slow reading. Equalizer Settings This setting is set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 45). With the Equalizer settings, you can adjust the tone of speakers individually with a 5-band equalizer. The volume of each speaker can be set on page 69. Notes: · You can select: "63Hz", "250Hz", "1000Hz", "4000Hz", or "16000Hz". [. . . ] And, you can charge your iPod or iPhone while listening to your music. Notes: · Before using the UP-A1, update your iPod or iPhone with the latest software, available from the Apple Web site at: www. apple. com · For the latest information on the UP-A1, see the Onkyo Web site at: www. onkyo. com · The instructions in this manual apply to the iPod and iPhone as of December 2008, and may change with future upgrades to the iPod or iPhone software. *1 iPod is a trademark of Apple Inc. , registered in the U. S. * "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. "Works with iPhone" means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. [. . . ]