User manual ONKYO HT-S5200

[. . . ] Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 7. 1ch Home Theater System Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 HT-S5200 AV Receiver (HT-R570) Speaker Package (HTP-570) Front Speakers (SKF-570 L/R) Center Speaker (SKC-570) Surround Speakers (SKR-570 L/R) Surround Back Speakers (SKB-570 L/R) Subwoofer (SKW-570) Turning On & First Time Setup . . . . . 38 Basic Operations. . . . . . . . . . . . . . . . . . . . . . . . . 44 Dock for iPod (UP-A1L) Using the Listening Modes . . . . . . . . 64 Instruction Manual Advanced Setup . . . . . . . . . . . . . . . . . . . . . . . . . . 70 Controlling Other Components . . . . 78 Others. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 84 Thank you for purchasing an Onkyo 7. 1ch Home Theater System. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new 7. 1ch Home Theater System. Please retain this manual for future reference. En WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Treble You can boost or cut high-frequency sounds output by the front speakers from ­10 dB to +10 dB in 2 dB steps. A BC A: The number of front channels (front left, front right, and center). B: The number of surround channels (surround left and surround right). C: LFE channel for subwoofer (1 means yes). 46 Basic Operations--Continued Using the Music Optimizer The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that use "lossy" compression, such as MP3. To turn the Music Optimizer "On" or "Off", use the AV receiver's [MUSIC OPTIMIZER] button. The setting is stored individually for each input selector. Tip: This procedure can also be performed on the remote controller by using [AUDIO] button (see page 77). Note: The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48 kHz and analog audio input signals. The Music Optimizer is disabled when the Direct listening mode is selected. · If the beginnings of tracks from a PCM source are cut off, try the PCM setting. · If noise is produced when fast forwarding or rewinding a DTS CD, try the DTS setting. · The setting is stored individually for each input selector. RECEIVER , AUDIO 1 Press the [RECEIVER] button, and then press and hold [AUDIO] button for about 8 seconds. Specifying the Digital Signal Format The following table shows the display indicator for each digital signal format. Format Dolby Digital DTS PCM PCM Display 2 Normally, the AV receiver detects the format of digital input signals automatically. However, if you experience either of the following issues when playing PCM or DTS sources, you can specify the signal format manually. While "Auto" is displayed (about 3 seconds), use the Left and Right [ ]/[ ] buttons to select: PCM, DTS, or Auto. PCM: Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indicator will flash and there will be no sound. DTS: Only DTS format input signals will be heard. If the input signal is not DTS, the DTS indicator will flash and there will be no sound. Auto (default): The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead. 47 Listening to the Radio AM/FM Frequency Step Setup 4 RECEIVER Use the Left and Right [ ]/[ ] buttons to select: 200k/10k: Select if 200k/10k steps are used in your area. 50k/9k: Select if 50k/9k steps are used in your area. Setup closes. 5 ENTER SETUP For AM/FM tuning to work properly, you must specify the AM/FM frequency step used in your area. Note that when this setting is changed, all radio presets are deleted. Note: This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 1 Press the [RECEIVER] button, followed by the [SETUP] button. 2 Use the Up and Down [ ]/[ ] buttons to select "8. Hardware", and then press [ENTER]. 3 Use the Up and Down [ ]/[ ] buttons to select "FM/AM". 48 Listening to the Radio--Continued Listening to AM/FM Stations TUNER TUNING Manual Tuning Mode 1 Press the [TUNING MODE] button so that the AUTO indicator disappears from the display. 2 TUNING MODE With the built-in tuner, you can enjoy AM and FM radio stations and store your favorite stations as presets for easy selection. [. . . ] · Make sure the correct input is selected on your TV or the AV receiver. · Some versions of the iPod do not output video. The AV receiver's remote controller doesn't control your iPod · Make sure your iPod is properly inserted in the Dock. If your iPod is in a case, it may not connect properly to the Dock. [. . . ]