User manual ONKYO HT-S6505

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] In this case, “TV Speaker” appears on the AV receiver’s display by pressing DISPLAY. € When “HDMI Ctrl (RIHD)” is set to “On”, this setting is fixed to “Auto”. € With some TVs and input signals, no sound may be output even when this setting is set to “On”. € When “Audio TV Out” or “HDMI Ctrl (RIHD)” is set to “On” and you’re listening through your TV’s speakers (➔ page 15), turning up the AV receiver’s volume control will make the sound be output from the AV receiver’s front left and right speakers. To stop the AV receiver’s speakers producing sound, change the settings, change your TV’s settings, or turn down the AV receiver’s volume. € Listening mode cannot be changed when this setting is set to “On” and the input source is not HDMI. En-52 Advanced Operations ■ Audio Return Ch (ARC) Off Auto: The audio signal from your TV tuner can be sent to HDMI OUT of the AV receiver. The audio return channel (ARC) function allows an ARC capable TV to send the audio stream to HDMI OUT of the AV receiver. To use this function, you must select the TV/CD input selector and your TV must be ARC capable. The ARC indicator will light when the audio signal is detected. Default setting: “- - - -” Note • This setting is fixed to “- - - -” when the “HDMI Ctrl (RIHD)” setting is set to “Off”. € This setting is set to “Auto” automatically when the “HDMI Ctrl (RIHD)” setting is set to “On” for the first time. € If you set “Audio Return Ch” to “Auto”, the “Audio Selector” settings of the TV/CD input selector will be automatically switched to “ARC” (➔ page 50). – InstaPrevue These settings apply to “InstaPrevue” of the Home menu (➔ page 38) and specify the preview display of HDMI video streams. With this setting, you can set the number of preview thumbnails displayed. Position (with “Sub Window” set to “Multi”) Top, Bottom, Left, Right (with “Sub Window” set to “Single”) UpperL, UpperR, LowerL, LowerR With this setting, you can set the position of preview thumbnails on the TV screen. Note • Depending on video signals, the picture may not be properly rendered on the preview thumbnails of InstaPrevue. Network Setup 1 2 3 4 “Setup” 5 Menu Network Setup After modifying the network settings, you must confirm the changes by executing “Save”. This section explains how to configure the AV receiver’s network settings manually. If your router’s DHCP server is enabled, you don’t need to change any of these settings, as the AV receiver is set to use DHCP to configure itself automatically by default (i. If, however, your router’s DHCP server is disabled (you’re for example using static IP), you’ll need to configure these settings yourself, in which case, a knowledge of Ethernet networking is essential. DHCP (Dynamic Host Configuration Protocol) is used by routers, computers, the AV receiver, and other devices to automatically configure themselves on a network. [. . . ] Personal Station: You can play tracks from personalized station (“Your Library”, “Your Neighbourhood” and “Your Recommendations”). ■ Using scrobbling control Use q/w to select “Enable” , and then press ENTER. * Internet radio services provided by a third party may be terminated with or without notice. Internet radio services may not be available in some areas. [. . . ]