User manual ONKYO MD-2321

[. . . ] Contents Before using MiniDisc Recorder MD-2321 Instruction Manual Important Safeguards. . . . . . . . . . . . . . . . . . . . . . . . 2 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Supplied accessories. . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The track numbers are recorded automatically. Since the interval between tracks is detected based on the sound level, some tracks may not be numbered correctly in the following cases: · Recorded condition of the cassette tape is bad (noise between tracks). · Low sound level in quiet music. · Interval between tracks is extremely short. · Tuner's reception is bad (noise). To disable this function refer to the explanation below on this page. To manually record a track number While recording, press the q REC button when you wish to mark a track number. If you wish to mark two or more track numbers sequentially, provide a sufficient interval between each press of the q REC button. Too short (about 4 seconds or less) an interval may lead to a failure in marking track numbers. Press the PAUSE button (or the button on the remote controller). To resume recording, press the ® PLAY button again (or press the ® button on the remote controller). Press the s STOP button, then the EJECT button. Caution: The TOC indicator flashes: If you press the button or the STAND-BY/ON button while the MD recorder is still writing the recorded contents onto the disc. During this period, do not disconnect the power cord or allow the MD recorder to vibrate. Doing so may prevent normal recording onto the MD. If the MD recorder's power cord is connected to the SWITCHED service power outlet on the rear panel of another device, do not turn off the power to the device. To disable the automatic track numbering function. . . Perform the following steps prior to Step 2 or Step 6: 1. "LevelSync?" appears on the display. If the function is currently turned on, "OnOff?" appears on the display. "LvlSyncOff" appears on the display. Now the tracks will not be numbered during recording. [. . . ] · The total recorded time and the remaining time on the disc may not total the maximum recording time (60 or 74 minutes) Recording is done in minimum units of two seconds each, no matter how short the material. The contents recorded may thus be shorter than the maximum recording capacity. Disc space may also be further reduced by scratches. · Tracks created through editing may exhibit sound dropout during searching operations Playing MD recorder Digital output terminal Optical cable or coaxial digital connecting cable Digital input terminal Recording MD recorder · Track numbers are not recorded correctly Incorrect assignment or recording of track numbers may result (1) when CD tracks are divided into several smaller tracks during digital recording, or (2) when certain CDs are recorded with both the LEVEL-SYNC indicator on and the automatic track marking function on. [. . . ]