User manual ONKYO P-3060

[. . . ] · Do not put water or other liquids close to the speakers. If liquid is spilled over the speakers, the drive units may be damaged. · As explained in this manual, mount the speakers on a wall, or on the optional stands/brackets, otherwise, they may fall, causing personal injury or damage to the speakers. * In catalogs and on packaging, the letter at the end of the product name indicates the color. [. . . ] The rubber stoppers prevent the speakers from moving, providing a more stable platform. Use thick rubber stoppers for the SKC-22X, and thin rubber stoppers for the SKR-22X Thin rubber stoppers Keyhole slot for wall mounting Thick rubber stoppers Wall 5 to 10 mm (3/16" to 7/16") 183 mm (7-3/16") Bottom of the SKR-22X Mounting the SKR-22X To mount the SKR-22X speakers, use the keyhole slot shown to hang each speaker on screw that is securely screwed into the wall. SKR-22X Wall Thick rubber stoppers 5 to 10 mm (3/16" to 7/16") 50 mm (1-15/16") 12 mm (1/2") Keyhole slot for wall mounting Thick rubber stoppers Bottom of the SKC-22X Wall Mounting The speakers can easily be wall mounted by using the keyhole slots. Mounting the SKC-22X To mount the SKC-22X speaker, use the two keyhole slots shown to hang the speaker on two screws that are securely screwed into the wall. The distance between the keyhole slots is 183 mm (7-3/16"). Caution: A mounting screw's ability to support a speaker depends on how well it's anchored to the wall. If you have hollow walls, screw each mounting screw into a stud. If there are no studs, or the walls are solid, use suitable wall anchors. Use screws with a head diameter of 9 mm (5/16") or less and a shank diameter of 4 mm (1/8") or less. With hollow walls, use a cable/ pipe detector to check for any power cables or water pipes before making any holes. Leave a gap of between 5 mm (3/16") and 10 mm (7/16") between the wall and the base of the screw head, as shown. High-pitched sounds generated by an oscillator, electronic musical instrument, and so on. Special test tones from audio test CDs and so on. Thumps and clicks caused by connecting or disconnecting audio cables (Always turn off your amplifier before connecting or disconnecting cables. ) 7. · The speakers contain strong magnets, so do not put magnetic or iron objects such as screwdrivers close to them. If you do, the object may be attached to the magnets, causing personal injury or damage to the diaphragm. Use with a TV Set or Computer TVs and computer monitors are magnetically sensitive devices and as such are likely to suffer discoloration or picture distortion when conventional speakers are placed nearby. To prevent this, the SKC-22X and SKR-22X speaker features internal magnetic shielding. In some situations, however, discoloration may still be an issue, in which case you should turn off your TV or monitor, wait 15 to 30 minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field, thereby removing any discoloration effects. If discoloration problems persist, try moving the speakers away from your TV or monitor. [. . . ] Note that discoloration can also be caused by a magnet or demagnetizing tool that's too close to your TV or monitor. Speaker Care Wipe the cabinet occasionally with a dry silica or soft cloth. For heavier dirt, after dampening a soft cloth in a weak solution of mild detergent and water and wringing it out dry, wipe off the dirt. Then, dry immediately with a clean cloth. [. . . ]