User manual ONKYO PA-MC5500

[. . . ] Contents Before using . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 9-Channel Amplifier Operations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 PA-MC5500 Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Instruction Manual Appendix. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Thank you for purchasing an Onkyo 9-Channel Amplifier. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new 9-Channel Amplifier. Please retain this manual for future reference. En WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Note: Do not change the INPUT SELECT switch setting when the amplifier is turned on. Connect the control amplifier to the amplifier. After selecting the correct input type in step 3 above, connect the output from the control amplifier to the corresponding input terminal on the amplifier. Note: Do not connect anything to the other input jack. Connect the supplied power cord to the amplifier and to the wall power outlet. Be sure to properly plug the power cord all the way in. When you connect other device to the 12V TRIGGER IN terminal using the supplied cable, the power on or off status of the amplifier synchronizes to the action of turning on or off the connected device. While the STANDBY indicator lights red, the amplifier is in standby state waiting for 12V trigger signal. Slowly increase the control amplifier volume. Note: After the amplifier is turned on, it takes approximately 10 seconds before the output sounds. During this time, do not turn up the volume. Now all that remains is to control the control amplifier and the other connected system components and enjoy your music or movies. 7 Front & Rear Panels Front Panel POWER switch This is the main power switch. When set to OFF, the amplifier is completely shutdown. It must be set to ON to set the amplifier to On or Standby. ON/STANDBY button This button is used to set the amplifier to On or Standby. Note: If you wish to turn on the amplifier again after it is turned off, wait for several seconds. STANDBY indicator The amplifier is in standby state and waits for instruction signal from the 12V TRIGGER IN terminal. ON indicator The main power of the amplifier is turned on and you can play and enjoy an input source. Notes: · If the POWER switch is pressed and both of the ON and STANDBY indicators do not light, check that the power cord is properly connected. If the indictors still do not light, turn off the amplifier, disconnect the power cord from wall outlet, and contact your Onkyo dealer. · If the STANDBY indicator flashes red, the protection circuitry of the amplifier has activated. The protection circuitry activates if a problem such as a speaker cable shorting or excessive temperature occurs. Turn off the amplifier, remove the cause of the problem, and then turn it back on. [. . . ] · Incorrect INPUT SELECT switch setting. Set INPUT SELECT switch to correct setting. · The protection circuitry has been activated. Remove the power cord from the wall outlet immediately. [. . . ]