User manual ONKYO RC-607M REMOTE CONTROL CODES

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safety Instructions 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] Such chemicals will do irreparable damage to the disc's plastic surface. Storage precautions · Discs should be returned to their cases after use to avoid dust and scratches that could cause the laser pickup to "skip". · Do not expose discs to direct sunlight or high humidity and temperature for extended periods. Long exposure to high temperatures will warp the disc. · CD-R and CD-RW discs are more sensitive to the effects of heat and ultraviolet rays than ordinary CDs. It is important that they are not stored in a location where direct sunlight will fall on them, and away from sources of heat such as radiators or heat-generating electrical devices. If you are in any doubt as to the care and handling of a disc, read the precautions supplied with the disc, or contact the disc manufacturer. Caution · Do not play any disc that is warped, deformed or damaged. Playing such discs may cause irreparable harm to the playing mechanisms. · Printable discs are not recommended, as the label side might be sticky and damage the unit. · Do not stick papers or protective sheets on the discs and do not use any protective coating spray. · Use a soft oil-based felt-tipped pen to write the information on the label side. Never use a ball-point or hard-tipped pen, as this may cause damage to the recorded side. Press LINE repeatedly to switch between LINE 1 and LINE 2. Also, each time INPUT on the unit is pressed, the source changes as follows: · DVD Source · iPod · USB Source · FM Radio · LINE1 Source · LINE2 Source Play the source, and adjust the volume using VOL . You can rotate the VOLUME knob on the unit to reduce or bring up the volume continuously. · Press ON/STANDBY to put the unit in the standby mode when it is not being used. 3 Setting the Clock 1 2 If the unit is on, press it standby. ON/STANDBY to turn Press CLOCK to show the time on the display. · The time appears on the display (if the time is not set after it blackout, "--:--" blinks). Press CLOCK again, the "hour" value starts blinking. · When no button is pressed for 30 seconds, the time setting mode will be cancelled. Press VOL to set the current hour. 3 4 5 6 Press CLOCK. The "minute" value starts blinking. Press VOL to set the current minute. Press CLOCK. The clock starts. En 18 Basic Operation Recording a Source You can record a source onto a CD recorder or a cassette tape recorder connected to the COAXIAL DIGITAL AUDIO OUT jack or the LINE OUT jacks. Listening to a Disc 1 2 3 4 5 Press DVD to select "DVD Source". [. . . ] Check for any scratches or smudges on the disc. Press MENU to exit the system setup menu. Disable the password for parental control or change the rating level. If condensation is suspected, unplug the AC power cord and leave RC-607M for two to three hours in the room temperature before playing any discs. iPod No Sound or Video Make sure your iPod is connected properly. [. . . ]