User manual ONKYO RC-622M REMOTE CONTROL CODES

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safety Instructions 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] To view the TV picture while setting, press ENTER. To return to the previous screen, press RETURN. If video signal delay occurs during playback on a video component (i. e. game console), select the corresponding input source and set the "Game Mode" setting to "On". The delay will decrease but in return the picture quality will become poor. Wide Mode*1*5 This setting determines the aspect ratio. 4:3: Picture Mode*1 Custom: All settings can be performed manually. Cinema: Selected when the picture source is movie film, etc. Game: Selected when the picture source is game console. Through: Default values are adapted for all settings. With "Picture Mode", you can change the following settings to be suitable for the movie or game screen by one operation; "Film Mode", "Edge Enhancement", "Mosquito NR", "Random NR", "Block NR", "Resolution", "Brightness", "Contrast", "Hue", "Saturation", "Gamma", "Red Brightness", "Red Contrast", "Green Brightness", "Green Contrast", "Blue Brightness", "Blue Contrast". 720p: Select this for 720p output and video conversion as necessary. 1080i: Select this for 1080i output and video conversion as necessary. 1080p: Select this for 1080p output and video conversion as necessary. When the "Monitor Out" is set to "Analog", this setting will be changed to "1080i". 1080p/24: Select this for 1080p output at 24 frames per second and video conversion as necessary. When the "Monitor Out" is set to "Analog", this setting will be changed to "1080i". You can specify the output resolution for the HDMI outputs and have the AV receiver upconvert the picture resolution as necessary to match the resolution supported by your TV. Available only when "Source" has been selected in the "Resolution" of the "Monitor Out" setting ( 48). Brightness*1*2*4 ­50 to 0 to +50 With this setting you can adjust the picture brightness. Contrast*1*2*4 ­50 to 0 to +50 With this setting you can adjust contrast. Hue*1*2*4 ­20 to 0 to +20 With this setting you can adjust the red/green balance. "­20" is the strongest green. [. . . ] If the error persists, please contact Onkyo Support and provide the error code. 7 *-14 8 9 10 11 Others Go to "Firmware Update" menu. Select "Via USB" and press ENTER. Select "Update" and press ENTER. As the updating progresses, the TV screen may disappear depending on the program updated. [. . . ]