User manual ONKYO SKB-750 SETTING MEMO

[. . . ] The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. only use attachments/accessories specified by the manufacturer. [. . . ] Mounting vertically To mount the front speakers vertically, use the keyhole slot shown to hang each speaker on a screw that's securely screwed into the wall. These threaded inserts can be used to attach the speaker either horizontally or vertically to a speaker mount or bracket. The center speaker base is for mounting the center speaker horizontally. If you put it on a TV stand or AV stand, aim it toward the listening position. The center speaker should sit securely on the base. The cradle surface of the base features two stoppers to prevent the speaker from moving. Therefore, you can tilt the speaker toward the front by up to 11 degrees. Mounting horizontally To mount the center speaker horizontally, use the two keyhole slots shown to hang each speaker on two screws that are securely screwed into the wall. Getting to know Your Speaker Package--Continued Caution: A mounting screw's ability to support a speaker depends on how well it's anchored to the wall. If you have hollow walls, screw each mounting screw into a stud. If there are no studs, or the walls are solid, use suitable wall anchors. Use screws with a head diameter of 3/8" or less and a shank diameter of 1/8" or less. With hollow walls, use a cable/pipe detector to check for any power cables or water pipes before making any holes. Leave a gap of between 1/4" and 5/16" between the wall and the base of the screw head, as shown. (We recommend that you consult a home installation professional. With the Auto Standby function, the SKW-750 automatically turns on when an input signal is detected in Standby mode. When there's no input signal for a while, the SKW-750 automatically enters Standby mode. This control is used to adjust the volume of the subwoofer. This RCA input should be connected to the subwoofer pre out on your AV receiver, amp, or other receiver with supplied RCA cable. Note: The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on your receiver or amp. Read the following before connecting your speakers: · Turn off your receiver or amp before making any connections. [. . . ] Putting them on uneven or unstable surfaces, where they may fall and cause damage, will affect the sound quality. If the unit is used near a turntable, CD player or DVD player, howling or slipping of sound may occur. To prevent this, move the unit away from the turntable, CD player or DVD player otherwise lower the unit's output level. Wipe the cabinet occasionally with a dry silica or soft cloth. [. . . ]