User manual ONKYO TA-RW344

[. . . ] TA-RW544/344 Ster eo Cassette Instruction Manual Tape Deck EJECT DECK A/B RESET EJECT DECK A DECK B 2 MOTER COMPUTER CONTROL DUBB. STOP 2 MOTER COMPUTER CONTROL AUTO REVERSE / / AUTO REVERSE POWER PHONES REVERSE MODE DUBBING NORMAL HIGH REC BALANCE REC LEVEL DOLBY NR ON OFF L R MIN MAX STEREO CASSETTE TAPE DECK TA-RW544 CONTENTS Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Set the Reverse Mode by pressing the REVERSE MODE button repeatedly until the desired mode is displayed. ( v ) one side: Only one side of the tape is recorded. ( b ) repeat: Both sides of the tape are recorded. · When recording from a source component to Deck A and Deck B consecutively, select the " b " mode. Note: This deck will not begin recording if you press the t and s or a button at the same time. To begin recording, first press the t button to put the deck into the rec/ pause mode, then press either the s or a button as appropriate. 8 (A) Recording on a single cassette using Deck A or Deck B 27 4 5 eDUBB. STOP The following explanation assumes that Deck B is being used. Procedure for recording 2 DECK A/B RESET DECK-B B 3 4 t s REC PAUSE DECK-B B 5 REC BALANCE REC LEVEL DECK-A DOLBY NR C L dB R REC PAUSE DECK-B -20 -10 -6 -3 0 +3 +6 B L R MIN MAX (TA-RW544 only) 6 7 e s e DUBB. (See page 8. ) Note: With TA-RW544, when recording to Deck A only, do not insert a cassette in Deck B. In the " b " mode, recording in Deck B may start consecutively. Press the DECK A/B button to select the appropriate Deck A or B, and press the RESET button to return the tape counter to [0000]. While observing the peak level indicators, adjust the recording level and balance. · Use the REC LEVEL knob to adjust the recording level. · With TA-RW544, adjust the REC BALANCE knob so that the left and right channels have approximately the same levels. This knob is normally at the center position. · When using metal cassettes, the REC LEVEL knob should be adjusted so that +3 dB indicators light periodically. When using other kinds of tapes, the 0 dB indicator should light periodically. (See "Making Good Sound Recordings" on page 13. ) 6. Put the source component into recording standby status. · Temporarily stop CD (or LP) play. · Rewind the tape to the portion you wish to start playback. Press the s button on this unit and begin playing the source component. [. . . ] · Hoarse sound, balance unstable. Remedy: Tape is probably bad but confirm by listening to another. Cause: Recording was done at too high a level. Remedy: Readjust REC LEVEL knob according to the directions on page 9. [. . . ]