User manual ONKYO TX-82

[. . . ] 19 Instruction Manual Recording . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Thank you for purchasing an Onkyo Stereo Receiver. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new Stereo Receiver. [. . . ] FM ANTENNA (12, 13) This socket is for connecting an FM antenna. SPEAKERS A (11) These lever terminals are for connecting speaker set A. SPEAKERS B (11) These lever terminals are for connecting speaker set B. (15) These (Remote Interactive) jacks can be connected to the jacks on other Onkyo CD player and cassette recorder. The TX-82's remote controller can then be used to control those components. Note: To use , you must make an analog audio connection between the TX-82 and the other component. can only be used with Onkyo components. G PHONO IN (14) These jacks can be used to connect a turntable with a moving-magnet cartridge. H CD IN (14) These jacks can be used to connect a CD player with an analog output. I TAPE 1, 2 IN/OUT (14) This analog audio input and output can be used to connect a cassette recorder, CD recorder, or other recorder with an analog input and output. Alternatively, they could be used to connect a graphic equalizer. J AC OUTLET (15) This switched AC outlet can be used to supply power to another component. B C D E F 8 Remote Controller 1 2 3 4 5 POWER SLEEP 6 TAPE-1 INPUT SELECTOR TUNER PHONO CD TAPE-2 DECK-A DECK-B GROUP TUNER PRESET MUTING 7 8 CD DISC VOLUME REMOTE CONTROLLER RC-330S A POWER button (16) This button is used to set the TX-82 to On or standby. · If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion. · Expired batteries should be removed as soon as possible to prevent damage from leakage or corrosion. Notes: · The remote controller may not work reliably if the TX-82 is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. · If another remote controller of the same type is used in the same room, or the TX-82 is installed close to equipment that uses infrared rays, the remote controller may not work reliably. · Don't put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. · The remote controller may not work reliably if the TX-82 is installed in a rack behind colored glass doors. · The remote controller will not work if there's an obstacle between it and the TX-82's remote control sensor. 10 Connections Connecting Speakers Before you connect your speakers, read the following: · Disconnect the power cord from the wall outlet. · Read the instructions supplied with your speakers. · Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals only to positive (+) terminals, and negative (­) terminals only to negative (­) terminals. If you get them the wrong way around, the sound will be out of phase and will sound odd. · The impedance of each speaker connected to this unit must be no lower than 4 ohms. [. . . ] · Make sure that the inputs and outputs of all components are properly connected (page 11­15). · Make sure that the polarity of the speaker cables is correct and that the bare wires are in contact with metal part of each speaker terminal (page 11) · Make sure that the input source is properly selected (page 17). · If the AUDIO MUTE indicator is shown on the display, press the remote controller's [MUTING] button to unmute the TX-82 (page 17). · If your turntable has a moving coil (MC) type cartridge, you'll need a commercially available MC head amp (page 14). [. . . ]