User manual ONKYO TX-903

[. . . ] 5 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Before using remote controller . . . . . . . . . . . . . . . . . . . . . . . . . 7 Facilities and connections Front panel facilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Remote controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] DTS Cinema The level can be adjusted to either - or between -10 to 0 decibels in 1-decibel increments. For DTS input source signals set to a listening mode of DTS Film, THX, Theather-Dimensional, Mono Movie, Action, or Musical, the LFE level becomes that set here. A setting of 0 decibels is recommended for optimum performance; however, if the low frequency range is too strong, lower this setting as necessary. DTS Music The level can be adjusted to either - or between -10 to +10 decibels in 1-decibel increments. For DTS input source signals set to a listening mode of DTS, Enhanced 7, Orchestra, Unplugged, Studio-Mix, TV Logic, or All Ch Stereo the LFE level becomes that set here. A setting of 0 decibels is recommended for optimum performance; however, if the low frequency range is too weak, higher this setting as necessary. MPEG Cinema The level can be adjusted to either - or between -10 to 0 decibels in 1-decibel increments. For MPEG input source signals set to a listening mode of MPEG Film, THX, Theather-Dimensional, Mono Movie, Action, or Musical, the LFE level becomes that set here. A setting of 0 decibels is recommended for optimum performance; however, if the low frequency range is too strong, lower this setting as necessary. MPEG Music The level can be adjusted to either - or between -10 to +10 decibels in 1-decibel increments. For MPEG input source signals set to a listening mode of MPEG, Enhanced 7, Orchestra, Unplugged, Studio-Mix, TV Logic, or All Ch Stereo the LFE level becomes that set here. OPT2: Select if connected to DIGITAL INPUT (OPTICAL) 2. OPT3: Select if connected to the DIGITAL INPUT (OPTICAL) 3. COAX1: Select if connected to DIGITAL INPUT (COAXIAL) 1. COAX2: Select if connected to DIGITAL INPUT (COAXIAL) 2. COAX3: Select if connected to DIGITAL INPUT (COAXIAL) 3. COAX4: Select if connected to DIGITAL INPUT (COAXIAL) 4. COAX5: Select if connected to DIGITAL INPUT (COAXIAL) 5. ­ ­ ­ ­: Select if the input source is not from a digital input jack. Digital Format The default setting is "Auto. " If "----" is selected for this input source at the Digital Input setting, then this setting will not appear. Although you can use this default setting as is, you may change it as desired depending on the input signal format (e. g. , if you know that you will always be listening to a certain input signal format from a particular input source). 34 Input Setup Auto: Select for automatic detection of the input signal format. The input signal format (Dolby Digital, DTS, MPEG, PCM or Analog) used by the selected input source is detected automatically to execute the required decoding process. [. . . ] If a system installer will install your system for you, then ask him to fill in this page for you. Example: If you connected a Onkyo DV-S525 to the DVD input, then enter "ONKYO DV-S525" for the name, circle items corresponding to the connections and settings that you have made, and fill in the items where blanks are given. VIDEO 2 Name: Digital Input: OPT1, OPT2, OPT3, COAX1, COAX2, COAX3, COAX4, COAX5, not connected Yes, No DVD, VIDEO1, VIDEO2, VIDEO3, VIDEO4, VIDEO5, not connected INPUT1, INPUT2, INPUT3, not connected VIDEO1, VIDEO2, COMPONENT, not connected DVD, VIDEO1, VIDEO2, VIDEO3, VIDEO4, VIDEO5, ---__________dB Yes (name:_________________) , No ________________________________ ________________________________ ________________________________ ________________________________ ________________________________ ________________________________ Inputs DVD Name: Digital Input connection: OPT1, OPT2, OPT3, COAX1, COAX2, COAX3, COAX4, COAX5, not connected Multichannel Setup: Yes, No Video Input Video: DVD, VIDEO1, VIDEO2, VIDEO3, VIDEO4, VIDEO5, not connected Component Video: INPUT1, INPUT2, INPUT3, not connected Video Output: VIDEO1, VIDEO2, COMPONENT, not connected Video Setup: DVD, VIDEO1, VIDEO2, VIDEO3, VIDEO4, VIDEO5, ---Intelli Volume: __________dB Character Input: Yes (name:_________________) , No Listening Mode Preset 1. Input source signal: ________________________________ Listening Mode: ________________________________ 2. Input source signal: ________________________________ Listening Mode: ________________________________ 3. [. . . ]