User manual ONKYO TX-DS575X

[. . . ] Contents Before using AV Receiver TX-DS575X Instruction Manual Important Safeguards. . . . . . . . . . . . . . . . . . . . . . . . 2 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Supplied accessories. . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Refer to the following sections for more information on adjusting the speaker level: "Test Tone (Remote controller only)" on page 16. "When Multi channel input is selected as a source" on page 19. 20 Using Listening Mode Before Using Listening Mode Listening Modes The TX-DS575X's surround sound enables you to enjoy the presence of a movie theater or concert hall in your room. Before using a listening mode, make sure the Speaker Setup parameters have been set (refer to page 14). Once the parameters have been set, it is not necessary to set them again. The configuration of the speakers are very important for the surround sound. Refer to "connecting speakers" on page 10. · A system with L/R front and center speakers The following modes are available: DOLBY 3 STEREO The surround channel sound is output from the left and right front speakers. Surround mode is cancelled. · A system with L/R front speakers The following mode is available: STEREO This is a normal stereo mode. DOLBY DIGITAL Surround, DTS (Digital Theater System) Surround This 5. 1-channel digital surround format enables you to individually record and play five full-range (20Hz­20kHz) channels (left and right front, center, two surround channels) plus an LFE channel (Low Frequency Effect) for the low-range effect sound. It will create a realistic sound that could be heard in the theaters and concert halls. DOLBY DIGITAL: Select this option when you play a DVD video that has a mark. DTS: Select this option when you play a DVD player, laser disc, or CD that has a mark. DIGITAL Notes on DTS 1. If you play a CD or LD that supports DTS when the "ANALOG" setting is selected on the TX-DS575X, the DTS encoded signal will not be decoded and noise will be output. This noise could damage the amplifier and speakers. Therefore, be sure to select "DIGITAL" and use the digital input jacks (OPTICAL/ COAXIAL) to connect the DTS source. (Refer to "Assigning the digital input/Selecting the input signal format" on page 18. ) 2. If you play a CD or LD that supports DTS when the "DIGITAL" setting is selected, you may hear a noise for a short while until the DTS decoder recognizes the DTS encoded signal and starts operating. If you press the PAUSE or SKIP button on the player while playing a DTS source, a short noise may be heard. The DTS indicator on the TX-DS575X lights up while it plays the DTS source. When playback concludes and the DTS signal transmission stops, the TX-DS575X remains in DTS mode and the DTS indicator remains lit. This prevents noise when you operate the PAUSE or SKIP button on the player. Therefore, if the source switches from the DTS signal to the PCM signal immediately, the PCM signal may not be played. In this case, stop the playback of the source on the player for about three seconds, then resume playback. Some CD players and LD players may be unable to play DTS sources correctly even if you connect the player to the TXDS575X digitally. [. . . ] & Canadian models: Other area models: 87. 5 -- 108. 0 MHz 11. 2 dBf, 1. 0 µV (75 ohms) 17. 2 dBf, 2. 0 µV (75 ohms) 17. 2 dBf, 2. 0 µV (75 ohms) 37. 2 dBf, 20 µV (75 ohms) 2. 0 dB 40 dB 85 dB 41 Control positions and names 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 PTY/TP MEMORY FM MUTE / MODE DOWN TUNING UP DIGITAL/ ANALOG SP / SYS SETUP MASTER VOLUME CH LEVEL MODE STANDBY/ON UP PRESET / MODE ADJ DOWN UP STANDBY POWER ENTER / SCAN ON OFF A SPEAKERS B DISPLAY STEREO LISTENING MODE /DTS SURROUND 5 CH STEREO DSP LATE NIGHT / FRONT EFFECT Re -EQ LFE LEVEL CONTROL DO W N BASS PHONES TREBLE MULTI CH INPUT DVD VIDEO 1 VIDEO 2 VIDEO 3 TAPE FM AM PHONO CD AV RECEIVER TX-DS575X 26 25 24 23 22 21 20 19 a b c d e f g hi SPEAKERS Display A B SLEEP AUTO STANDBY MPEG PC M DIGITAL DOLBY DIGITAL DOLBY PRO LOGIC DTS DSP STEREO DIRECT TUNED FM STEREO FM MUTE MEMORY RDS ft ch dB j Front panel For more information about buttons or knobs, refer to the pages listed in the brackets ( [ ] ) below. DIMMER button [17] or PTY/TP button (European model only) [28] 7. Display (Refer to the "Display" illustration. ) 8. LISTENING MODE buttons STEREO button [22] /DTS SURROUND button [22] 5 CH STEREO button [22] DSP /® (DOWN/UP) buttoun [22] 9. [. . . ]