User manual ONKYO TX-NR1010

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] Note • If the “Dolby Volume” setting is set to “Off”, this setting cannot be selected. DTS ■ Neo:X Music Center Image 0 to 2 to 5 The DTS Neo:X Music listening mode creates 9-channel surround sound from 2-channel stereo sources. With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel. Changing the value from “0” to “5” will spread the sound of the center channel to left and right (outwards). En-70 Advanced Operations Audyssey DSX® ■ Soundstage –3dB to Reference to +3dB With this setting, you can adjust the sound stage when using Audyssey DSX. Note • This listening mode can be selected only when all the following conditions are satisfied: – The center speaker is connected. € Either the front high or front wide speakers are connected. LFE Level ■ Dolby Digital*1, DTS*2, Multich PCM, Dolby TrueHD, DTS-HD Master Audio, DSD*3 –QdB, –20dB, –10dB, or 0dB With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for each input sources. If you find that low-frequency effects are too loud when using one of these sources, change the setting to –20 dB or –Q dB. , processing when the Pure Audio or Direct listening mode is selected. Note • When Digital Processing Crossover Network is being used, this setting is not available. Sound Program Edit ■ Sound Program Stereo Source 1, Stereo Source 2, Stereo Source 3, Multich Source 1, Multich Source 2, Multich Source 3 When playing back different content types on the same source, or when listening to a single content type on different sources, you can pre-register the settings that best suit each content in “Sound Program”. The registered settings can then be called up and modified in one set. use “Sound Program Edit” to register and modify a combination of settings. Tip • To select the registered settings, see “Sound Program” (➔ page 55). Theater-Dimensional ■ Listening Angle Wide: Select if the listening angle is greater than 30 degrees. Narrow: Select if the listening angle is less than 30 degrees. With this setting, you can optimize the TheaterDimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings. Front left speaker Front right speaker Listening angle: 30° Dolby Digital and Dolby Digital Plus sources DTS and DTS-HD High Resolution sources DSD (Super Audio CD) sources Direct ■ Analog Subwoofer Off On: Analog audio signals (bass signals) are output. This setting determines whether or not analog audio signals (bass signals) are output from front speakers when the Pure Audio or Direct listening mode is selected. Note • If the “Subwoofer” setting is set to “No” (➔ page 64), this setting cannot be selected. [. . . ] Personal Station: You can play tracks from personalized station (“Your Library”, “Your Neighbourhood” and “Your Recommendations”). ■ Using scrobbling control Use q/w to select “Enable” , and then press ENTER. * Internet radio services provided by a third party may be terminated with or without notice. Internet radio services may not be available in some areas. [. . . ]