User manual ONKYO TX-NR609

[. . . ] Contents AV Receiver Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 TX-NR609 Instruction Manual Connections. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Turning On & Basic Operations . . . . . . 22 Advanced Operations . . . . . . . . . . . . . . . . . 43 Controlling Other Components. . . 63 Appendix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 69 Thank you for purchasing an Onkyo AV Receiver. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. En Introduction WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] With this setting, you can optimize the TheaterDimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings. Front left speaker Front right speaker 20°/40° LFE Level Dolby Digital*1, DTS*2, Multich PCM, Dolby TrueHD, DTS-HD Master Audio, DSD*3 ­ dB, ­20dB, ­10dB, or 0dB With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for each input sources. If you find that low-frequency effects are too loud when using one of these sources, change the setting to ­20 dB or ­ dB. *1 *2 Dynamic EQ Off On: Audyssey Dynamic EQ® becomes active. With Audyssey Dynamic EQ, you can enjoy great sound even when listening at low volume levels. Audyssey Dynamic EQ solves the problem of deteriorating sound quality as volume is decreased by taking into account human perception and room acoustics. It does so by selecting the correct frequency response and surround volume levels moment-by-moment so that the content sounds the way it was created at any volume level -- not just at reference level. Note · These technologies cannot be used when: ­ a pair of headphones is connected, or ­ either Pure Audio (European, Australian and Asian models) or Direct listening mode is selected. En *3 Dolby Digital and Dolby Digital Plus sources DTS and DTS-HD High Resolution sources DSD (Super Audio CD) sources 50 Reference Level Audyssey Dynamic EQ® Reference Level Offset 0dB: This should be used when listening to movies. 5dB: Select this setting for content that has a very wide dynamic range, such as classical music. 10dB: Select this setting for jazz or other music that has a wider dynamic range. This setting should also be selected for TV content as that is usually mixed at 10 dB below film reference. 15dB: Select this setting for pop/rock music or other program material that is mixed at very high listening levels and has a compressed dynamic range. Movies are mixed in rooms calibrated for film reference. To achieve the same reference level in a home theater system each speaker level must be adjusted so that ­30 dBFS band-limited (500 Hz to 2000 Hz) pink noise produces 75 dB sound pressure level at the listening position. A home theater system automatically calibrated by Audyssey 2EQ® will play at reference level when the master volume control is set to the 0 dB position. At that level you can hear the mix as the mixers heard it. Audyssey Dynamic EQ is referenced to the standard film mix level. It makes adjustments to maintain the reference response and surround envelopment when the volume is turned down from 0 dB. However, film reference level is not always used in music or other nonfilm content. Audyssey Dynamic EQ Reference Level Offset provides three offsets from the film level reference (5 dB, 10 dB, and 15 dB) that can be selected when the mix level of the content is not within the standard. Note · If "Dynamic EQ" setting is set to "Off", these technologies cannot be used. Note · If you want to use Audyssey Dynamic EQ or Dynamic Volume with THX listening modes, set the "Loudness Plus" setting to "Off" and set "Preserve THX Settings" to "No" ( page 48). · If you make Dynamic Volume active, "Dynamic EQ" is set to "On". · When "Dynamic EQ" is set to "Off", "Dynamic Volume" is automatically switched to "Off". · These technologies cannot be used when: ­ a pair of headphones is connected, or ­ either Pure Audio (European, Australian and Asian models) or Direct listening mode is selected. About Audyssey Dynamic EQ® Audyssey Dynamic EQ solves the problem of deteriorating sound quality as volume is decreased by taking into account human perception and room acoustics. Dynamic EQ selects the correct frequency response and surround levels moment-by-moment at any user-selected volume setting. [. . . ] Turn on the power of the Blu-ray Disc/DVD player/recorder. Start playback on the Blu-ray Disc/DVD player/recorder, and verify the following. · The AV receiver automatically turns on, and selects the input to which the Blu-ray Disc/DVD player/recorder is connected. · The TV automatically turns on, and selects the input to which the AV receiver is connected. [. . . ]