User manual ONKYO TX-NR727

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] You cannot select speakers that you set to “No” or “None” in the “Speaker Configuration” (➔ page 59). Note • When the Direct or Pure Audio (European, Australian, and Asian models) listening mode is selected, the equalizer settings have no effect. • If “Audyssey” is enabled , it prevails over this setting (➔ page 64). – BGC Off On If your listening room layout (for practical or aesthetic reasons) locates most of the listeners close to the rear wall, the resulting bass level can be sufficiently reinforced by the boundary that the overall sound becomes “boomy”. € If the “Subwoofer” setting is set to “No”, this setting cannot be selected (➔ page 60). Operating procedure (➔ page 56) En-61 Advanced Operations ■ Loudness Plus Off On When the “Loudness Plus” setting is set to “On”, it is possible to enjoy even subtle nuances of audio expression at low volume. This is only available when the THX listening mode is selected. – Preserve THX Settings Yes No If this setting is set to “Yes”, Dynamic EQ and Dynamic Volume have no effect in THX listening mode. Audio Adjust With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like. dolby ■ PL IIx Music (2ch Input) These settings apply to only 2-channel stereo sources. If you’re not using any surround back speakers, these settings apply to Dolby Pro Logic II, not Dolby Pro Logic IIx. Panorama On Off With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music listening mode. Dimension –3 to 0 to +3 With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic IIx Music listening mode. Higher settings move the sound field backward. If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move it backward. Center Width 0 to 3 to 7 With this setting, you can adjust the width of the sound from the center speaker when using the Dolby Pro Logic IIx Music listening mode. Normally, if you’re using a center speaker, the center channel sound is output from only the center speaker. (If you’re not using a center speaker, the center channel sound will be distributed to the front left and right speakers to create a phantom center. ) This setting controls the front left, right, and center mix, allowing you to adjust the weight of the center channel sound. multiplex/Mono ■ Multiplex Input Channel Main Sub Main/Sub This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on. [. . . ] Personal Station: You can play tracks from personalized station (“Your Library”, “Your Neighbourhood” and “Your Recommendations”). ■ Using scrobbling control Use q/w to select “Enable” , and then press ENTER. * Internet radio services provided by a third party may be terminated with or without notice. Internet radio services may not be available in some areas. [. . . ]