User manual ONKYO TX-NR900

[. . . ] Contents AV Receiver Before using 2 TX-NR900 TX-NR900E Facilities and connections 8 Instruction Manual Setup and operation 31 Thank you for purchasing the Onkyo AV Receiver. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. Remote controller 66 Appendix 78 E WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] When connecting CD players and other digital components, do not connect only the digital terminals, but the analog ones as well. · There are some restrictions on recording digital signals. When making digital recordings, consult the instruction manual that came with your digital recording equipment (e. g. , MD recorder or DAT deck) to know what restrictions are imposed. · You cannot record the source connected to the MULTI CHANNEL INPUT connector. 3. Start recording at the recording component as desired. To confirm the settings, press the Rec Out button. The current settings will appear for 8 seconds in the front display. Notes: · Be aware that the remote (Zone 2) and recording (REC OUT) outputs use the same circuit and therefore cannot be used at the same time. · You cannot record the surround effects. · Digital signals input to the DIGITAL INPUT (COAX) and DIGITAL INPUT (OPT) inputs will be output to the DIGITAL OUTPUT (OPT) outputs. · There are some restrictions on recording digital signals. When making digital recordings, consult the instruction manual that came with your digital recording equipment (e. g. , MD recorder or DAT deck) to know what restrictions are imposed. · You cannot record the source connected to the MULTI CH INPUT connector. · You cannot listen to a broadcast from one station while recording the broadcast from another. 40 Recording a source Recording the video from one source and the audio from another You can add the sound from one source to the video of another source to make your own video recordings. Below is an example of recording the sound from a compact disc player connected to CD IN and the video from a video camera connected to VIDEO 5 INPUT to video cassette tape in a video cassette recorder connected to the VIDEO 1 OUT jack. Set "VIDEO 5" for the Video setting in the Video Setup sub-menu of the Setup menu: Input Setup Video Setup Video. Insert a CD in the CD player and insert a tape in the video camera connected to the VIDEO 5 INPUT. Insert a video tape for recording in the video cassette recorder connected to VIDEO 1 OUT. Press the REC OUT button repeatedly until "Rec Sel:SOURCE" appears in the front display. Now "CD" has been selected as the audio input source and "VIDEO 5" as the video input source. Start recording on the video cassette recorder and start playing at the CD player and video camera as desired. Notes: · If you change the input source during recording, you will record the audio signals from the newly selected input source and the video signals assigned to that input source. [. . . ] "Not available with Multichannel use" Operation not allowed while the multi-channel output is being used. "Not available in this Sp Config" Will not work with the current speaker configuration settings. "Not available in Zone 2 mode" Setting not allowed because the Zone 2 mode is turned on. "Only available with Dolby D" No setting other than Dolby Digital can be set. [. . . ]