User manual ONKYO UP-HT1

[. . . ] only use attachments/accessories specified by the manufacturer. Unplug this apparatus during lightning storms or when unused for long periods of time. refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ] â· For best results, install the outdoor FM antenna well away from tall buildings, preferably with a clear line of sight to your local FM transmitter. â· Outdoor antenna should be located away from possible noise sources, such as neon signs, busy roads, etc. For safety reasons, outdoor antenna should be situated well away from power lines and other highvoltage equipment. â· Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards. If good reception cannot be achieved using the supplied AM loop antenna, an outdoor AM antenna can be used in addition to the loop antenna, as shown. It's best not to use the same antenna for both FM and TV reception, as this can cause interference problems. You can control the UP-HT1 with your Universal Port-compatible Onkyo product's remote controller. Aim it at your Universal Port-compatible Onkyo product, not the UP-HT1. You can use the following buttons on your Universal Port-compatible Onkyo product's remote controller. Used to select radio presets by number, and to enter AM/FM station frequencies. With AM and FM, you can select a station directly by entering its frequency. Used to view various information on the display. With AM and FM, this button selects the Auto or Manual tuning mode. With AM and FM, the Up and Down [ ]/[ ] buttons are used for tuning. With AM and FM, these buttons are used for tuning. Lights up when tuned to an HD Radio station. Lights up when an HD Radio station provides multicast channel program. FM STEREO Lights up when an analog audio is being received in a stereo reception. (It indicates the status of analog audio during digital HD Radio reception. ) DIGITAL Lights up when a digital HD Radio transmission is being received. ANALOG Lights up when an analog HD Radio transmission is being received. This display information shows an example. [. . . ] Note: If the signal from an RDS station is weak, RDS data may be displayed intermittently or not at all. The RDS indicator lights up when tuned to an FM radio station that supports RDS. When tuned to an RDS station that's broadcasting PS information, the station's name will be displayed. With the Preset Write function, you can preset individual FM and AM radio stations. [. . . ]