User manual ONKYO UWL-1

[. . . ] Wireless USB Audio Transport Contents Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Transmitter (UTX-1) . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Receiver (RX-1) Front and Top . . . . . . . . . . [. . . ] If you can't relocate your PC, using a commercially available USB extension cable and moving the Transmitter to another location may resolve the issue. If you're using a powered USB hub, make sure its AC adapter is plugged in when you use the UWL-1. · Always stop audio playback on your PC before plugging in or unplugging the Transmitter. It's OK to plug in or unplug the Transmitter while your PC is on. · If your PC has several USB ports, you can plug the Transmitter into any port. Note that some PCs may detect the Transmitter as a new device if you plug it into another port. In this case, simply allow Windows® to perform the installation again. · Always plug the Transmitter into your PC before starting playback. If you plug it in after starting playback, the audio will not be transmitted. · While the Transmitter is plugged into your PC, your PC's built-in speakers will not output any sound. This is because USB audio devices have priority. To output sound from your PC's built-in speakers, unplug the Transmitter, or change the Default device setting on the Audio tab of the Sounds and Audio Devices Properties control panel (see page 19). If Windows® doesn't install the drivers automatically, unplug the Transmitter, wait about 15 seconds, then plug it in again. If it still doesn't install them, follow the procedure below: 1. 5. Click the Start button, and then click Control Panel. Click Performance and Maintenance, and then click System. Select the Hardware tab, and then click the Device Manager button. Double-click the corresponding item in the device list to open the Properties window. Select the Driver tab, click the Update Driver button to open the Add Hardware Wizard, and follow the onscreen instructions to install the drivers. 9 Setting Up the UWL-1--Continued Connecting the Receiver (RX-1) · Before making any connections, read the manuals supplied with your other components. · Don't connect the AC adapter until you've completed and double-checked all connections. Connection Color Coding RCA-type audio connections are usually color-coded: red and white. Use red plugs to connect right-channel audio inputs and outputs (typically labeled "R"). [. . . ] · Turning off any energy saving settings may also improve performance. Recording Can't record on the component connected to the Receiver's optical digital jack · For copyright reasons, it's not possible to record from the Receiver's optical digital jack. Note: The UWL-1 uses microcomputers for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this should happen, unplug the Transmitter and the Receiver's AC adapter, wait at least 5 seconds, and then plug them back in again. 17 Troubleshooting--Continued Confirming Driver Installation You can confirm that the necessary drivers for the UWL-1 are installed. Windows® XP Click the Start button, click Control Panel, click Performance and Maintenance, and then click System. [. . . ]