User manual OPTEX MORSE GENESYS 824 ALPHA

[. . . ] By selecting the appropriate Quad Key TM and pressing the button, users can easily select the level of security they desire. If you would like to deselect a Quad Key TM before arming, press the key a second time. Then, either select another Quad Key TM or press # to reset the system to it's `Home' Mode. Clear If your Quad Keys control Arming Modes, only one mode may be used at a time. To shift from one mode to another, enter your code to disarm and then re-arm with the mode you desire. [. . . ] This chime can be turned on or off by pressing + 1 while the system is disarmed. Two short beeps indicate that the Chime has been turned on, one long beep indicates that the Chime has been turned off. Arming your system automatically turns off the chime. Ask your security company if you would like the chime to turn on automatically everytime you turn off your security system. [2] Smoke Detector Reset If your system has smoke detectors, press +2 + 2 to reset the smoke detectors after an alarm [3] System Walk Test +3 Test your system monthly to ensure proper operation Follow this recommended procedure: · Call your monitoring company to let them know you are testing your system. · Confirm that all zones are ready (Green ready light is On). · Press + 3 to initiate `Walk Test Mode'. The display will show "Walk Test" on the top line and automatically scroll through the name of each zone on the bottom line (except for FIRE zones and 24Hr. zones (these zones must be tested by the security company). · Activate each detector to confirm proper operation. As each zone is activated, its name will be deleted from the scrolling list on the bottom line of the display (check each detector seperately if there is more than one detector on a zone). When all zones have been activated, the display will briefly show "None Found" and return to normal operation. The display will show the zone number and the status of the selected zone. Zones which are normal, open, or `in-trouble' can be bypassed. Zone 01 is Normal Zone 01 Is Open Zone 01 Is In Trouble Zone 01 Is Bypassed Press to bypass the selected zone or to remove bypass. After adjusting the zone, # press to move to the next zone or to return to Zone Bypass Mode. Press # a second time to exit Zone Bypass Mode. Clear Clear Zone bypass is erased every time you disarm. If you bypass zones regularly, ask your security company about programming Quad Key buttons to automate this process for you. A PIN number can be required before pressing 6 to bypass zones. company if you would like this feature added to your system. Ask your security [7] Installer Programming This area is for security company use only. [8] User Programming + 8 + User PIN System Users with appropriate authority can set User PINs, system time, auto-armimg time, and other advanced features in this section. Only User PINs with authority levels 01 and 02 can access this area. See below for instructions regarding User Programming. [9] No Entry Delay Arming & Utility Output 11:33am 08/17/05 Armed Instant +9 During the exit delay period, enter + 9 to arm your system without entry delays. All armed zones will create an alarm instantly. [. . . ] Now enter the 4 digits you wish to use for the PIN number, press , set the two digit authorization level and press . Either continue entering codes and authorization levels, or press # two times to exit User PIN programming. (see below for more information regarding User PIN Authorization Levels) 8 If you continue, Vision will automatically advance to the address of the next PIN and wait for a four digit code + + two digit autorization level , etc. . . and automatically return to `Home' of User Programming after the eigth user PIN is programmed. [. . . ]