User manual OPTICON MSL 1000

[. . . ] Undecoded Laser Scan Engine MSL 1000 The MSL 1000 laser scan engine is a compact laser barcode scan engine that can be installed in various handheld products. Specifications Manual Opticon MSL 1000 Specifications Manual All information subject to change without notice. Document History Model Number: Edition: Date: MSL 1000 2 2008-04-17 Specification Number: Original Spec Number: SS06025 SS05010 Copyright 2008 Opticon. All rights reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or machine readable form without prior written consent of Opticon. Limited Warranty and Disclaimers PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING OR USING THE PRODUCT. Serial Number A serial number appears on all Opticon products. This official registration number is directly related to the device purchased. [. . . ] Abstract This document provides specifications on the MSL 1000 laser scan engine. 2. Overview The MSL 1000 laser scan engine (hereafter referred to as the "scan engine") is a compact laser barcode scan engine that can be installed in various handheld products such as portable terminals. When scanning a target from the minimum decode distance, this scan engine can scan up to 44 mm wide at an angle of 44°. The use of short wave-length red laser beam enhances visibility when scanning lines. This scan engine scans barcodes using laser light and outputs barcode images in logic level signals (hereafter referred to as "signal"). The scan engine also outputs timing waveforms (signals) synchronized with scanning. Such timing waveforms (signals) (hereafter referred to as "TIMING"). This scan engine can be turned on and off via external input signal "POWER EN". The laser light emission of this scan engine can be controlled via external input signal "LASER EN". This scan engine is compliant with RoHS-mandated requirements. 3. Dimensions W 28 x D 14 x H 7. 9 mm 3. 2. Weight 9 g (max. ) 5 Opticon MSL 1000 Specifications Manual 4. Laser Scan Specifications Parameter Light-emitting element Emission wavelength Light output Scanning method Scanning speed Scan angle Specification Red laser diode 650 ±10 (25° C) 1. 0 or less Bi-directional scanning 100 ±20 Scan angle: 54 ±5 Read angle: 44 (Min) Unit -- nm mW -- scans/s ° ° 6. 2. Tilt of Laser Scan Line (The maximum tilt in between both ends of the scan line. ) Less than 1. 2 degrees upward tilt from the scan origin (MM mirror). Maximum of 3. 1 millimeters when measured at the point 150 millimeters away from the scan origin. (The measurement is taken at the center of the scan line. ) · · 8 Opticon MSL 1000 Specifications Manual 6. 3. Curvature of Scanning (The maximum gap between the straight line connecting both ends of the laser scan line and the actual laser scan line. ) · Less than 1. 27 degrees curvature from the scan origin. · Maximum of 3. 3 millimeters when measured at the point 150 millimeters away from the scan origin. (The measurement is taken at the center of the scan line. ) re Curvatu Tilt H o riz o n ta l L in e Figure 2. Technical Specifications The conditions for technical specifications are as follows, unless otherwise specified in each section. Conditions Ambient temperature and humidity: Ambient light: Background: Room temperature (5 to 35º C) Room humidity (45% to 85% RH) 500 to 900 lx Barcode = black Space = white Margin = white Background of label = black 3. 3 V Approve the performance when decoding is successful in all ten tests. (over 92%) (Decoding is deemed successful when completed in 0. 5 seconds or less. ) Power supply voltage: Decoding test: 7. 1. [. . . ] Reliability MTBF (Mean Time Between Failures) of this product except for the laser diode and the mirror motor scan unit is 30, 000 hours. Life cycle of the laser diode is 10, 000 hours and that of the mirror motor scan unit is also 10, 000 hours. The estimate of MTBF and product life cycle is based on standard operation of the product within the recommended temperature range and without extreme electronic or mechanical shock. 24 Opticon MSL 1000 Specifications Manual 13. Laser Safety The scanner emits laser beams. [. . . ]