User manual OPTICON OPR 3101

[. . . ] Rugged Wireless Laser Barcode Scanner OPR 3101 The OPR 3101 scanner uses Bluetooth technology for wireless transmission of scanned barcode data. Specifications Manual Opticon OPR 3101 Specifications Manual All information subject to change without notice. Document History Model Number: Edition: Date: OPR 3101 1A 2009-08-31 Specification Number: Original Spec Number: SS07028 SS07012 Copyright 2007 Opticon. All rights reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or machine readable form without prior written consent of Opticon. Limited Warranty and Disclaimers PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING OR USING THE PRODUCT. Serial Number A serial number appears on all Opticon products. This official registration number is directly related to the device purchased. [. . . ] Shows that the scanned data is being stored to the memory of the scanner. Wireless Connection Blue Blinking Shows that the scanner is making a connection to wireless communication line. Shows a successful connection to wireless communication line. Shows a failure or error in making a connection to a wireless communication line. Shows that the scanner has disconnected the wireless communication line. Red Lighting Lighting Wireless Disconnected Red Lighting Shows that the wireless communication is disconnected because the scanner is outside the communication range. Shows that the battery level is becoming very low. The scanner must be charged. Low Battery Level Red Blinking 12 Opticon OPR 3101 Specifications Manual 6. Laser Scan Specifications Parameter Light-emitting element Emission wavelength Light output Scanning method Scanning speed Scan angle Specification Red laser diode 650 ±10 (25° C) 1. 0 or less Bi-directional scanning 100 ±20 Scan angle: 54 ±5 Read angle: 44 (Min) Unit -- nm mW -- scans/s ° ° mm Auto-trigger IR detection area 40 Notes: Refer to chapter 14, "Trigger and Read Options, " to read about the scan modes. Refer to chapter 7, "Technical Specifications, " to read about scanning performance. 6. 2. Laser Scan Tilt Laser scanning tilt is the vertical difference between both ends of a laser scan line. Measure it in the middle of the laser scan line. · Less than 1. 2° angle in vertical direction from the scan origin (mirror motor). · Up to 3. 1 mm when measured at a point 150 mm from the scan origin. (The skew angle of this measurement was 0°. ) 6. 2. 2. Curvature of Scan The maximum difference between the laser scan line and the line between both ends of the laser scan line. Measure it in the middle of the laser scan line. · Up to 1. 27° angle in vertical direction from the scan origin (mirror motor). · Up to 3. 3 mm curvature when measured at a point 150 mm away from the scan origin. 13 Opticon OPR 3101 Specifications Manual Figure 3: Laser scan tilt and curvature 7. Technical Specifications The conditions for technical specifications are as follows, unless otherwise specified in each section. Conditions Ambient temperature and humidity: Ambient light: Background: Room temperature (5 to 35º C) Room humidity (45% to 85% RH) 500 to 900 lx Barcode = black Space = white Margin = white Background of label = black 3. 7 V Approve the performance when decoding is successful in all ten tests. (Decoding is deemed successful when completed in 0. 5 seconds or less. ) Power supply voltage: Decoding test: 7. 1. Print Contrast Signal (PCS) 0. 45 or higher (over 70% of reflectivity of space and quiet zone). PCS= Reflectance of white barReflectance of black bar Reflectance of white bar Scanning performance may decline if dirt or scratches mar the optical window. [. . . ] FCC Part 15 Subpart B Class B: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15. 4. RoHS RoHS: The restriction of the use of certain hazardous substances in electrical and electronic equipment, 2002/95 EC. 32 Opticon OPR 3101 Specifications Manual 15. 5. R&TTE This scanner conforms to the following standards of the Radio and Telecommunications Terminal Equipment (R&TTE) directive from the EU. [. . . ]