User manual OPTOMA CM-E73X

[. . . ] · Solid wood surface: a beam, or a wood joist inside the wallboard. · Wallboard: sheet rock, plasterboard or paneling. · Masonry: plaster, cement or brick. [. . . ] Select an appropriate projector mounting location and extension shafts (Part No. 9, 10, 11) needed, if any, to get the required projector position. Place the Heavy Duty Ceiling Mount Assembly (Part No. 3) in the desired location, using the mount as a template; mark the two slots onto the mounting surface. Refer to the TOGGLER® brochure "Anchoring Solutions, " (Part No. Then follow the instructions that are appropriate for the type of surface on which you will be attaching the Heavy Duty Ceiling Mount Assembly. Note: if you are using the Alligator® anchors, they must be installed in the center of the ceiling joist or beam. Installation along the edge of the joist can cause splitting. Drill the appropriate sized hole at each marked location and insert the previously selected anchor (Part No. Place the Ceiling Mount Assembly onto the anchors and insert two 2-inch wood screws (Part No. # 1 2 3 4 5 6 7 8 9 10 11 12 13 APPENDIX: PARTS LIST Description Projector Mount Assembly Projector Mount Screws Ceiling Mount Assembly TOGGLER® TC® anchor (not shown) TOGGLER® AF6 Alligator® anchor (not shown) TOGGLER® Red Key (not shown) #10 x 2" Truss Head Phillips Screws "Anchoring Solutions" brochure (not shown) 24" safety cable 6" Extension Shaft (not shown) 9" Extension Shaft (not shown) 1/4" Star Washers Hex Wrench Qty. 1 4 1 3 3 1 3 1 1 1 1 4 1 2. 3. 4. INSTALLING THE PROJECTOR MOUNT 1. Place the PROJECTOR upside down on a flat surface. Being careful not to damage the projector. Place the Heavy Duty Projector Mount Assembly (Part No. 1) onto the projector, lining up the three mounting holes. [. . . ] Make sure you placed a star washer in this joint also. Using two wrenches, tighten the two hexagon shafts and extension shafts, if any, compressing the star washers. On the Heavy Duty Projector Mount Assembly (Part No. [. . . ]