User manual OPTOMA EP729

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual OPTOMA EP729. We hope that this OPTOMA EP729 user guide will be useful to you.

Lastmanuals help download the user guide OPTOMA EP729.

Download

You may also download the following manuals related to this product:

OPTOMA EP729 Quick Start (621 ko)

Manual abstract: user guide OPTOMA EP729

Detailed instructions for use are in the User's Guide.

 [. . . ] Table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Usage Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  [. . . ] Otherwise the message will disappear after 25 seconds. The cooling fans continue to operate for about 120 seconds for cooling cycle and the Power LED will flash orange. When the light stops flashing,  the projector has entered standby mode. If you wish to turn the projector back on,  you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode,  simply press "Power/Standby" button to restart the projector. Disconnect the power cord from the electrical outlet and the projector. Do not turn on the projector immediately following a power off procedure. 

Warning Indicator
When the "TEMP" indicator turns red,  it indicates the projector has overheated. The projector will automatically shut itself down. When the "LAMP" indicator flashes red (0. 5 second intervals),  it indicates a problem with the lamp. Turn off the projector and disconnect the power cord from the electrical outlet,  then contact your local dealer or our service center. When the "LAMP" indicator flashes red (1 second intervals),  it indicates the fan failed. Stop using the projector and disconnect the power cord from the electrical outlet,  then contact your local dealer or our service center. 

English . . . 12

Installation
Adjusting the Projected Image
Adjusting the Projector Image Height
The projector is equipped with an elevator foot for adjusting the image height. 
To raise the image: 1. Raise the image to the desired height angle ,  then release the button to lock the elevator foot into position. Lower the image,  then release the button to lock the elevator foot into position. Use to fine-tune the display angle. 

1

Elevator Button
3 2

Tilt Adjusting Wheel Elevator Foot

13 . . . English

User Controls
Using the Remote Control Power

4 Refer to the "Power On/Off the Projector" section on pages
11-12. 

Source

4 Press "Source" to choose RGB,  Component-p,  Component-i, 
S-Video,  Composite Video and HDTV sources. 

Auto

4 Automatically synchronizes the projector to the input source. 
Keystone

4 Adjusts image distortion caused by tilting the projector (±8
degrees). Press "Keystone" button,  then use setting. 

to adjust the

Hide

4 "Hide" immediately turns the screen black. Press "Hide" again
to restore the displayed image. 

Laser Button

4 Aim the remote at the viewing screen,  press and hold this
button to activate the laser pointer. 

Freeze

4 Press "Freeze" to pause the screen image. 
Remark : "*" this is computer mode only. And these functions are only available when the projector is connected to a computer via an USB cable. 

Mouse/Mouse Right Click/Mouse Left Click (*)

4 These functions are the same as a mouse of PC or Mac. 
Four Directional Select Keys

4 Use
Enter

your selection. 

to select items or make adjustments to

4 Confirm your selection of items. 
Menu

4 Press "Menu" to launch the on screen display menu. To exit
OSD,  press "Menu" again. 

English . . . 16

User Controls
On Screen Display Menus
The Projector has multilingual On Screen Display menus that allow you to make image adjustments and change a variety of settings.  [. . . ] Refer to your computer's documentation for detailed information. 

Problem: Image is unstable or flickering

4 Use "Phase" to correct it. 4 Change the monitor color setting from your computer. 
Problem: Image has vertical flickering bar

4 Use "Frequency" to make an adjustment. 4 Check and reconfigure the display mode of your graphic card to
make it compatible with the product. 

27 . . . English

Appendices
Problem: Image is out of focus

4 Adjusts the Focus Ring on the projector lens.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE OPTOMA EP729

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual OPTOMA EP729 will begin.