User manual OPTOMA PK102

[. . . ] Do not install near heat sources such as radiators, heaters, stoves or any other apparatus such as amplifiers that emits heat. Do not use the projector in direct sunlight. Do not use near any appliance generating a strong magnetic field. Do not use the projector in areas susceptible to excessive dust and dirt. [. . . ] · Consult the dealer or an experienced radio/television technician for help. Notice: Shielded cables All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations. Caution Changes or modifications not expressly approved by the manufacturer could void the user's authority, which is granted by the Federal Communications Commission, to operate this device. Operation conditions This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ICES-003. DISpoSal of olD electrIcal & electronIc equIpment (Applicable throughout the European Union and other European countries with separate collection programs) This symbol found on your product or on its packaging, indicates that this product should not be treated as household waste when you wish to dispose of it. Instead, it should be handed over to an applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences to the environment and human health, which could otherwise be caused by inappropriate disposal of this product. The recycling of materials will help to conserve natural resources. This symbol is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal. Notice: Canadian users Remarque à l'intention des utilisateurs canadiens Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada. Declaration of Conformity for EU countries · EMC Directive 2004/108/EC (including amendments) · Low Voltage Directive 2006/95/EC · R & TTE Directive 1999/5/EC (if product has RF function) 2 proDuct overvIeW 1. DC Input 11 13 2 3 4 FOCUS 8 9 6 7 10 12 1 14 package overvIeW 1 7 10 InStallIng the Battery 1 2 AV IN 5 VGA \ USB IN 2 8 11 3 4 3 9 12 1. Insert battery with electrical contacts facing downward and away from lens. () 3. Ensure battery pull tab extends from under battery. Slide the battery cover back into place over battery pull tab. (~) VOLUM OL E CONTR 13 5 4 5 6 <Note> The standard accessories may vary in each region due to different applications. Standard Accessory 1. USB to DC jack cable 6 7 3 ChargIng the Battery 1 2 connect input source - (vIDeo In) 1. Remove protection cap and insert the plug. During charging the LED indicator lights red. () Projector will not charge while operating. The LED Charge Indicator will go off when battery is fully charged. This process may take up to 2. 5 hours <Note> 1. [. . . ] · Make sure the projector is switched on. Image is out of focus · Adjust the Focus Dial. · Make sure the projection screen is between the required distance 7. 9 to 103. 8 inches (0. 2 to 2. 636 meters) from the projector. Image is too small or too large · Move the projector closer to or further from the screen. [. . . ]