User manual ORBIT WATERMASTER

[. . . ] 15 The information in this manual is primarily intended for the user who will establish a watering schedule and enter that schedule into the Controller. This product is intended to be used as an automatic timer controller for activating 24 VAC irrigation valves, as described in this manual. Help: Before returning this timer to the store, contact Orbit® Technical Service at: Orbit® Technical Service: 1-800-488-6156 or 801-299-5555 Trademark Notice: WaterMaster® is a registered trademark of Orbit® Irrigation Products, Inc. S I T h of digit a flexibil w the co P the Co A B installi W W o You ma o a p verifies Fuse T m WTM000684 57096-24 rF. [. . . ] Figure 9: Ready for Automatic Operation. Only those stations assigned a watering duration will water when using the manual or semi-automatic mode [See Figure 11]. €¢ Figure 12: Manual Watering in Either the A or B Program Only Using Manual Operation The manual operation mode allows you to set durations in any of the six stations from 1 to 99 minutes. The display will show a blinking cursor on station 1 along with - - MINS [See Figure 13]. U To stop m Figure 14: Manual Watering Station 3 for Five Minutes Note: After the manual key has been pushed, if a selection is not made within 60 seconds the display returns to the time of day. Interrupting or Halting Timer Output The Timer has several built-in features that allow the user to momentarily interrupt or halt the electrical output to the station valves. figure 13 8 WTM000684 57096-24 rF. Qxd 3/6/06 11:00 AM Page 13 e n n • To momentarily interrupt the electrical output to the stations, press the off/auto resume button on the hand held wireless transmitter. This is useful for making a quick repair or pattern adjustment in the sprinkler system. To restart the electrical output, simply press the off/auto resume button once again. NOTE: The program will return where it would have, had the interruption not occurred. For instance, the Timer does not try to recapture any automatic watering which is lost due to the interruption. €¢ To halt or discontinue semi-automatic or manual watering, press the clear key once. The Timer will revert to your original automatic watering plan. Using the User Selectable Rain Delay Mode To stop automatic watering for 24, 48, or 72 hours, use the rain delay mode key. €¢ With the rotary dial set to auto, press the rain delay key once. the Timer will force a 24-hour interruption of all scheduled watering. After 24 hours, the Timer will automatically return to its initial watering schedule. €¢ To increase the rain delay to 48 or 72 hours simply press the rain delay key again until the desired delay time is displayed. €¢ To cancel the rain delay mode, press clear [See Figure 15]. €¢ Note: While in rain delay mode, the timer will display the remaining hours (counting down) to the end of the accepted delay alternating with the current time and date. No other key besides clear is accepted while the Timer is in the rain delay mode. [. . . ] Insert one of the two power leads from the transformer into each terminal. €¢ Slide the cover back on until it snaps. Stations turn on when they are not supposed to: 1. One station is stuck on and will not shut off: 1. [. . . ]